Hitachi 42PD9700C Service Manual page 37

Procedure of re-install new software of Digital module software for 42PD9700
1. RS232C cable should be connected to RS232C terminal of TV set.
RS232C cable should be connected.
2. TV set turn ON.
3. Press hold [S.MODE], [YELLOW] and [Blue] button of remote controller until appears the service menu.
4. Set data of No 888 from [0] to [1] then press [OK] button.
5. RS232C cable should be connected between TV set and PC.
6. Appeared programe menu after double crick Hyper Termi-
nal I con.
Condition of Transfer
Bit rate:115200
Data bit:8
Parity: none
Stop bit:1
Flow: none
7. Crick "Transfer" then select "File send".
8. Select required software file in the folder.
42PD9700C/U & 55PD9700C/U
36