Front of the unit ........................5 Back of the unit ........................5 Electrical:........................6 Video enhancement ..................... 7 4. HOW TO CONTACT NETMC MARINE SUPPORT ............7 APPENDIX 1 ...........................9 Technical Specifications ......................9 APPENDIX 2 .........................10 Wiring Pin-Out of Souriau Umbilical Connector ..............10 Spare parts: ..........................
VideoPWR camera/lamp controllers are designed to work with our customer’s own camera/lamps as requested: - Where a Souriau umibilical connector is fitted (see Appendix 2), the videoPWR unit has been designed specifically for use with Novasub underwater cameras parts CAMSS2.3TP and CAMSS2.4C, and Novasub LED lights part LUX6LSS1.4-12.
Camera output typically 24v DC Camera signal should be via co-ax unless unit has been ordered specifically with twisted pair line drivers – this is indicated on the product bar code. THIS EQUIPMENT MUST BE EARTHED. NETmcMarine videoPWR Rev3.2 4 of 15...
This prevents damage to any connected lamp and prevents inrush surges which might happen if no lamp is connected - which may blow fuses. Back of the unit Example - Dual channel videoPWR to work with Novasub cameras/lamps Connector for power 1 Video out 1...
Example single channel videoPWR, to work with Bowtech cameras L3C-550-A4, lamps LED- 800-13, no umbilical connector requested: Video Camera / connectors Lamp Power Connector Screw terminal instead of umbilical connector. See Appendix 4 3.3 Electrical: The units operate from 90 to 260 VAC input.
3.4 Video enhancement Video enhancement is an optional addition to a videoPWR unit, which must be ordered at the time of purchase. This feature uses Lyyn Visibility Enhancement Technology to improve visibility underwater by up to 60%. Please see Appendix 5 for more details on this feature.
Page 8
1. Whilst every effort has been made to ensure that the information contained in this manual is accurate, no liability can be accepted for errors and omissions. 2. Should this product be modified in any way by anyone other than a qualified NETmc Marine employee, then NETmc Marine cannot be held liable for any consequences.
After overnight road freight the units should be left at room temperature for 24 hours before powering After air freighting the units should be left at room temperature for 48 hours before powering on. NETmcMarine videoPWR Rev3.2 9 of 15...
Appendix 3 Wiring Pin-Out of Amphenol Umbilical Connector Amphenol part C01630H00610010 RS part: 540-1688 Protective cap: RS part 452-085 Lamp + Lamp - Video Signal Video Ground Video Power + 12v NETmcMarine videoPWR Rev3.2 11 of 15...