Product View; Getting Ready - Bissell 3698 User Manual

A

Product View

Do not plug in your cleaner until you have
completely assembled it per the following
instructions and are familiar with all instructions
and operating procedures.
1 Clean Water/Formula Tank
2 Dirty Water Tank
3 Power Button
4 Hose Clip
5 Float Stack
6 Flexible Hose
7 Power Cable
8 Quick Release™ Cable Wrap
B
Assembly
1. Slide hose clip into opening on front of
machine. You will hear a "snap" when it is
locked into place.
2. Snap hose grip bracket into back of
machine on clean tank side. Wrap hose
around the unit and snap hose grip
into bracket.
3. Attach cable wrap by snapping it into
place on dirty tank side of machine. Wrap
power cable around cable wrap.
Cleaning Formula
Always use genuine BISSELL deep
cleaning formulas for portable spot cleaners.
Non-BISSELL cleaning formulas may harm
the machine and will void the guarantee.
Use only BISSELL portable/compact machine formula
in your cleaner. Use of cleaning formulas which
contain lemon or pine oil may damage this appliance
and void the guarantee. Chemical spot cleaners or solvent-based soil
removers also should not be used. These products may react with the
plastic materials used in your cleaner, causing cracking or pitting.
To reduce the risk of fire and electric shock due to internal
component damage, use only BISSELL cleaning formulas
intended for use with the portable spot cleaner.
Keep spray away from face. Failure to do
so may result in personal injury.
9 Tough Stain Tool
10 Hose Grip
11 BISSELL SPOTCLEAN BOOST
Oxygen Boost Formula
12 BISSELL 2X SPOTCLEAN
Spot & Stain Formula
13 BISSELL 2X SPOTCLEAN
Pet Stain & Odour Formula
C
Operations

Getting ready

1. To fill clean water/formula tank
a. Remove tank by lifting it straight
up and away from unit.
b. Pull on black tab to reveal tank
opening. The plug rotates out of the
way for easy filling.
c. Your tank is marked for a large stain
or a small stain. Based on your cleaning
need, fill with hot tap water to the water
fill line. Add Oxygen Boost formula to
the OXYgen Boost fill line. Add BISSELL
2X formula to formula fill line. DO NOT
BOIL OR MICROWAVE WATER.
d. Replace plug by rotating into place
and pressing gently onto tank.
e. Replace tank by lining up tank
bottom with indentations on machine.
Press down firmly on tank to secure
in position.
2. Release hose from hose grip bracket.
Unwrap hose completely from around unit.
3. Insert Tough Stain Tool on end of hose
until it clicks into place.
4. Twist the Quick Release™ cable wrap
clockwise to unwrap power cable completely.
Cleaning with your spot cleaner
1. Plug unit in and turn on by pressing power
button under handle.
2. Hold cleaning tool approximately 2.5cm
above soiled surface. Press spray trigger to
apply cleaning solution to soiled area.
3. Using brush on cleaning tool, gently scrub
area to be cleaned.
4. For thorough cleaning, spray additional
solution while brush and suction are in
contact with surface.
5. Apply downward pressure on cleaning
tool and pull it toward you. The suction
will remove the dirt and cleaning solution.
Continue until no more dirt can be removed.
6. As a final step, use "drying strokes" (by
not pressing the spray trigger) to remove
as much liquid/moisture as possible. Repeat
this step as often as necessary.
7. When using Oxygen Boost formula, it will
continue to work for the next six to eight
hours cleaning your spots and stains all the
way to the backing of the carpet.
www.BISSELL.com
5