40kg of product at any set point temperature, in the range of –22ºC to +15ºC. ® Figure 1: Front view of Adande Compact Drawer ADE- 2030-B Page 3 of 11...
® Type: Adande Drawer Refrigeration Units ® Manufactured by Adande Refrigeration, 45 Pinbush Road, South Lowestoft Industrial Estate, Lowestoft, Suffolk NR33 7NL The following transposed harmonised European Standards have been used: EN ISO 12100 parts 1 & 2 Safety of Machinery – Basic concepts, general principles for design EN ISO 13857 Safety of Machinery –...
LEVEL” The drawer is capable of storing any food product. However, products which may give ® off acidic odours like vinegar, onions, etc should be suitably sealed. Adande also recommends storage containers with liquid food products be stored with lids.
Locking and Unlocking the Controller Locking and Unlocking the Controller Locking and Unlocking the Controller Locking and Unlocking the Controller a) a) a) a) Press and immediately release “i” “i” “i” “i” b) b) b) b) Press button “i” “i” “i” “i” again to display ‘T2’ button to display ‘T1’...
“DO” will flash on the display panel, if the drawer is still not closed after an additional 3 minutes then “HI” will be displayed. ® When the alarm has been activated, the Adande drawer will alarm both visually and audibly.
Location and Stability Location and Stability Location and Stability Location and Stability ® It is important that the Adande drawer is installed and maintained on a flat, clean and level surface level surface to ensure correct operation. level surface level surface The room should be dry and sufficiently ventilated.
Only use Adande Approved and Registered Service Engineers which can be supplied on request. Your Adande drawer should be regularly inspected and checked against the Your Adande drawer should be regularly inspected and checke d against the Your Adande drawer should be regularly inspected and checke...
7.0 Drawer Drawer Maintenance Maintenance Drawer Drawer Maintenance Maintenance Dirt and grease should be removed on a weekly basis using the following procedures: The heated seal should be cleaned on a weekly weekly weekly weekly basis with a solution of warm water and mild detergent.
WARRANTY REQUEST FORM Phone: (07) 3440 7600 Int: +617 3440 7600 Phone: 1300 307 289 Fax: (07) 3344 6166 Int: +617 3344 6166 Email: service@stoddart.com.au To ensure we can provide the best possible service we require you to complete this form. Make, model and serial number, along with other essential information.
Need help?
Do you have a question about the VCC and is the answer not in the manual?
Questions and answers