Troubleshooting And Maintenance; After Using The Product - HoMedics CIRCULATION PRO Instruction Manual

13-0095 CB200-CA_IM_E_vE.qxd:Layout 1
TROUBLESHOOTING & MAINTENANCE
Problem
Device will not turn on. - Batteries inserted in wrong direction.
Power turns off too
soon
Power turns off while
using massager
It is difficult to attach
Gel pad to the skin
Adhesive surface of
Gel pad is not sticky
It is difficult to feel
stimulation
The skin turns red or
the skin feels irritated
Hygiene

After using the product

Clean the device with a soft, damp cloth but make sure to squeeze the cloth dry, and to clean the foot pedal
area.
Store the Electrode Gel pads on the plastic pad protectors provided.
Storage
Keep the whole set clean and store it in a dust free and dry location under the following conditions
Storage temperature and humidity
Operating temperature and humidity
7/2/13
Cause
- The adapter does not plug into device properly.
- Gel pads not attached correctly to the skin.
- if you are using the batteries operation, then
the batteries weak/exhausted
- Treatment period of 30 minutes is over and
power turns off automatically
- if you are using the body massage, the
electrode gel pad may be broken
- Transparent film not peeled off
- Gel pad applied immediately after washing
- Adhesive surface of Gel pad damaged
- The gel pads get dirty and lost their
adhesive/stickiness
- Use of Gel pad while perspiring
- Gel pad washed too long and/or too frequently
- Gel pads stored under high temperature, high
humidity, direct sunshine
- You sole is too dry, not enough moisture
- Your sole is not placed on the foot pedal
properly
- Gel pads not attached correctly to the skin
- Gel pads overlap each other
- Electrode cord not connected correctly
- Applied intensity too weak
- Adhesive surface of Gel pads dirty or dry
- Adhesive surface of Gel pads damaged
-10°C to 60°C, 10% to 95% RH
-5°C to 50°C, 30% to 90% RH
2:05 PM Page 17
Rectification
- Insert batteries in correct direction or check the
battery is in full power.
- check the connection of the adapter jack is well
connected; and also the DC adapter is well
connected to the main socket.
- Attach Gel pads correctly to the skin
- Fit 4 new identical 1.5V alkaline batteries type
AA
- Restart treatment or turn off the massager.
-Replace electrode gel pad
- Peel off film on the adhesive surface of Gel pad
- Sufficiently dry Gel pad
- Replace Gel pad
- Replace Gel pad or clean the gel pad with a
small drop of water onto the sticky side of the
electrode pad and rub into the surface
Leave Gel pad in freezer for overnight
- Put some water to your sole to moisture your
sole
- Ensure both of your soles are placed on each
pedal properly.
- Attach Gel pad firmly to the skin
- Reattach Long Life pads with no overlap
- Connect electrode cord correctly
- Increase the intensity by pressing the + button.
- Wash adhesive surface of Gel pads softly with
your fingertips for about 3 seconds under slow
running water
- Replace Gel pads
17