Troubleshooting - Greenwood 63124 Owner's Manual & Safety Instructions

Inspection, Maintenance, and Cleaning
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
Do not use damaged equipment. If abnormal noise, vibration, or
leaking air occurs, have the problem corrected before further use.
Follow all guidelines regarding chemicals sprayed, including MSDS instructions and EPA regulations.
Release pressure in Tank by pulling up on the Pressure Release Valve before loosening
or removing parts. Contents are under pressure and may spurt forcefully.
1. BEFORE EACH USE, inspect the general
condition of the Sprayer. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.

Troubleshooting

Problem
Unit does not spray
Spray pattern is undesirable
Follow all safety precautions whenever diagnosing or servicing the Sprayer.
Record Serial Number Here:
Note: If product has no serial number, record month and year of purchase instead.
Note: Some parts are listed and shown for illustration purposes only, and
are not available individually as replacement parts.
Page 6
Possible Causes
1. Suction Tube (34) detached.
2. Not enough liquid in tank.
3. Handle Assembly loose.
4. Hose Nut (18) loose.
5. Safety Cap (22) loose.
6. Sprayer not pressurized.
7. Spray fluid contains
particles or sand.
8. Nozzle and/or Filter clogged
with mineral buildup.
1. Nozzle needs adjustment.
2. Spray fluid contains
particles or sand.
3. Nozzle and/or Filter clogged
with mineral buildup.
For technical questions, please call 1-888-866-5797.
2. AFTER EVERY USE, Clean the Sprayer:
a. Flush with water.
b. Clean Nozzle and Filter (35).
c. Rinse with water and allow to air-dry.
3. PERIODICALLY, lubricate all moving parts of
the pump assembly with petroleum jelly.
4. Store the Sprayer in a safe, dry, clean location
out of reach of children and out of sunlight.
Likely Solutions
1. Reattach Suction Tube.
2. Add liquid to tank.
3. Tighten Handle Assembly.
4. Tighten Hose Nut.
5. Tighten Safety Cap.
6. Pump Handle to pressurize Sprayer.
7. Disassemble, clean, then reassemble
Nozzle and/or Filter. Empty, clean, then
refill Tank with properly strained fluid.
8. Disassemble, clean, then reassemble
Nozzle and/or Filter.
1. Adjust Nozzle.
2. Disassemble, clean, then reassemble
Nozzle and/or Filter. Empty, clean, then
refill Tank with properly strained fluid.
3. Disassemble, clean, then reassemble
Nozzle and/or Filter.
Item 95690 / 63124