Advertisement
Advertisement
Table of Contents
Summary of Contents for Switch2 G6
- Page 1 Your G6 User Guide...
- Page 2 Allow you to interact with the G6 to cycle through menu screens, activate the emergency credit (in pay-as-you-go mode) or clear messages. PLEASE NOTE: The mode of operation of the G6 in your property is set by your housing association/ development management agent.
-
Page 3: Getting Started
In pay-as-you-go mode your G6 shows how much credit you have remaining and as you top-up available use energy credit is deducted accordingly. Your G6 will generally have a screen saver showing the Switch2 logo and this can be Getting started cleared with the press of either button to reveal your Home Screen. - Page 4 Please ensure that when your credit is running low, that you allow enough time for your The ‘Remaining Emergency Credit’ is £5.00, the supply is top-up to arrive on your G6. This will help you to avoid using the emergency credit facility, ‘ON’ and energy is currently available.
-
Page 5: In-Home Display
If you have lost your card, do not worry about someone finding and using your card, it is registered to you and your G6 only and cannot be used to top-up any other G6. Your card has no monetary value and is simply used to identify who has made payments. No money The G6 will return back to the home screen if no button is is stored on the card. - Page 6 G6 is controlling. consumed for each fuel as well as any daily deduction. If you are using your G6 with two supplies i.e. Heat and Gas your G6 screens will show The supply type and tariff charge (in pence) are shown both supply types indicated with the appropriate icon listed below.
- Page 7 *Please note if your G6 is replaced or reprogrammed, all historical data will be reset. If your G6 has power disconnected then the values for ‘Today’ and ‘Yesterday’ screens will be lost.
-
Page 8: Frequently Asked Questions
Have you checked the following: • Energy Advice Does your Home Screen say ON in the top right corner? • Do you have enough credit on your G6? • Have you activated your emergency credit? • Is your heating programmer turned on? •... - Page 9 Please DO NOT attempt to undertake any maintenance. The System should only be installed, programmed, removed or dismantled by an Switch2 technician. If the system is used in a manner not specified by Switch2, the protection level of the equipment may be impaired.
Need help?
Do you have a question about the G6 and is the answer not in the manual?
Questions and answers