Advertisement
*19102*
19102
1910S-1/L1910S-1
Horn Strobe and
Latching Horn Strobe
SPECIFICATIONS
Voltage:
12 or 24 VDC
Current:
28 mA maximum average
Temperature: 32° F to 120° F (not for outdoor use)
Customer Service
1-877-671-7011
www.allegion.com
Installation Instructions
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Summary of Contents for Schlage 1910S-1
- Page 1 *19102* 1910S-1/L1910S-1 Horn Strobe and 19102 Installation Instructions Latching Horn Strobe SPECIFICATIONS Voltage: 12 or 24 VDC Current: 28 mA maximum average Temperature: 32° F to 120° F (not for outdoor use) Customer Service 1-877-671-7011 www.allegion.com...
- Page 2 INSTALLATION Set horn strobe options. The following horn strobe options can be set in the field: Brightness: Strobe brightness measured in candella. Strobe brightness is set using the slider switch on the back of the horn strobe (Figure 1). Volume: High or low Tone: Electromechanical tone Code: Non-temporal code (continuous tone) or temporal code (interrupted tone).
- Page 3 Wire the horn strobe. Typical wiring for 1910S-1 horn strobe Power 1910S-1 Power Supply (+) Supply Horn Strobe Power Monitor Supply (-) Strike Door Position Figure 2, Wiring (front of mounting plate) Switch • Horn strobe activates when latchbolt retracts or when door opens.
- Page 4 Mount the horn strobe. Flush Mount a. Secure flush mount plate to 4” back box with two #8-32 x 3/4” screws. 4” back box b. Complete field wiring. recessed in wall c. Attach the horn strobe assembly to the mounting plate. Refer to Figure 6.
Need help?
Do you have a question about the 1910S-1 and is the answer not in the manual?
Questions and answers