Register Online - DeWalt DCE200 Instruction Manual

installing attachments or accessories. An
accidental start-up can cause injury.

WARNING: Before each use, inspect the tool
(including LED indicators) and correct any
problems before attempting to use.

WARNING: Skin injection hazard. The oil in the
mechanism is under extreme pressure. Do not
use hands to check for oil leaks.

WARNING: Explosion hazard. The internal
hydraulic system creates extreme pressures.
Only D WALT-qualified personnel should service
e
this tool.
Required Maintenance (Fig. A)
Maintenance is required when the pipe pressing tool
reaches 45,000 cycles. Warning indicators will illuminate on
the diagnostic panel as follows.
7
1. Maintenance warning at 44,500 cycles (Maintenance
LED lights yellow continuously)
2. Final maintenance warning at 44,900 cycles
(Maintenance LED flashes yellow continuously)
3. Needs service at 45,000 cycles (Maintenance LED lights
red for 10 seconds then turns tool off automatically).
At 45,000 cycles, the tool will no longer run. Take your
tool to a D WALT factory service center for maintenance
e
and recalibration.
Cleaning

WARNING: Blow dirt and dust out of all air vents with
clean, dry air at least once a week. To minimize the risk
of eye injury, always wear ANSI Z87.1 approved eye
protection when performing this.

WARNING: Never use solvents or other harsh
chemicals for cleaning the non-metallic parts of
the tool. These chemicals may weaken the plastic
materials used in these parts. Use a cloth dampened
only with water and mild soap. Never let any liquid
get inside the tool; never immerse any part of the tool
into a liquid.
Regularly clean the press jaws to be sure they are free of dirt
and debris to ensure a proper press.
Accessories

WARNING: Since accessories and attachments, other
than those offered or recommended by D
have not been tested with this product, use of such
accessories or attachments with this tool could be
hazardous. To reduce the risk of injury, only D
recommended accessories and attachments should
be used with this product.
Recommended accessories and attachments for use with
your tool are available at extra cost from your local dealer or
authorized service center. If you need assistance in locating
any accessory or attachment, please contact D
Industrial Tool Co., 701 East Joppa Road, Towson, MD 21286,
call 1-800-4-D WALT (1-800-433-9258) or visit our website:
e
www.dewalt.com.
For a complete and most up to date list of compatible jaws,
rings, attachments and fittings, visit www.dewalt.com.
Repairs
The charger and battery pack are not serviceable.

WARNING: To assure product SAFETY and
RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should
be performed by a D
or a D
identical replacement parts.

Register Online

Thank you for your purchase. Register your product now for:
• WARRANTY SERVICE: Registering your product will
help you obtain more efficient warranty service in case
there is a problem with your product.
• CONFIRMATION OF OWNERSHIP: In case of
an insurance loss, such as fire, flood or theft, your
registration of ownership will serve as your proof
of purchase.
• FOR YOUR SAFETY: Registering your product will
allow us to contact you in the unlikely event a safety
notification is required under the Federal Consumer
Safety Act.
Register online at www.dewalt.com/register.
Three Year Limited Warranty
D WALT will repair, without charge, any defects due to
e
faulty materials or workmanship for three years from the
date of purchase. This warranty does not cover part failure
due to normal wear or tool abuse. For further detail of
warranty coverage and warranty repair information, visit
www.dewalt.com or call 1-800-4-D
This warranty does not apply to accessories or damage
caused where repairs have been made or attempted by
others. This warranty gives you specific legal rights and
you may have other rights which vary in certain states
or provinces.
In addition to the warranty, D
by our:
D WALT will maintain the tool and replace worn parts
e
caused by normal use, for free, any time during the first year
WALT,
after purchase. The press tool wear items such as rollers,
e
roller pins, and roller holder are not covered.
2 YEARS FREE SERVICE ON DEWALT BATTERY PACKS
WALT
e
DC9071, DC9091, DC9096, DC9182, DC9280, DC9360, DCB120,
DCB127, DCB201, DCB203, DCB203BT, DCB207, DCB361
3 YEARS FREE SERVICE ON DEWALT BATTERY PACKS
DCB200, DCB204, DCB204BT, DCB205, DCB606
NOTE: Battery warranty voided if the battery pack is
WALT tampered with in any way. D
e
for any injury caused by tampering and may prosecute
warranty fraud to the fullest extent permitted by law.
WALT factory service center
e
WALT authorized service center. Always use
e
WALT (1-800-433-9258).
e
WALT tools are covered
e
1 YEAR FREE SERVICE
WALT is not responsible
e
11