Unpacking And Inspection; Hardware Installation And Connections - Fenger FIP-1100 Installation & Configuration Manual

Hd ip streaming server
Table of Contents

Advertisement

FENGER
System Installer must adhere to Article 820-40 of the NEC that provides guidelines
for proper grounding and specifies that the cable ground shall be connected to the
grounding system of the building, as close to the point of cable entry as possible.

UNPACKING and INSPECTION

Each unit is shipped factory tested. Ensure all items are removed from the container prior to discarding any
packing material.
Thoroughly inspect the unit for shipping damage with particular attention to connectors and controls. If there
is any sign of damage to the unit or damaged or loose connectors contact your distributor immediately. Do
not put the equipment into service if there is any indication of defect or damage.

HARDWARE INSTALLATION and CONNECTIONS

It is highly recommended that quality cables and connectors be used for all video and audio
source connections
1. Connect the media source (Satellite STB, Media player, or other media device) to the FIP-
1100 streaming server by HDMI, YPbPr, or CVBS cables.
2. Connect the FIP-1100 Streaming Server to local area network (LAN)
3. Plug the power adapter to the device and power up
4. Network Setup
5. In the same network segment, find the FIP-1100 Streaming Server from Windows XP/7 "My
Network Places"
** Note: For Windows XP enable UPnP.
6. Open the streaming server's configuration web page by double-clicking the device icon(XP)
7. There are three (3) use cases supported by FIP-1100 Streamer: DLNA media server,
UDP/RTP multicasting and TCP/UDP/RTP unicasting.
Limitations:
1. All UPnP/DLNA devices, including the FIP-1100 Streaming Server (media-server), media-
players, the Smart TV, the set-top-box, and the controlling PC, should be located within
same network segment/LAN.
2. If a DHCP server is present in the private network, the FIP-1100 Streaming Server will use
the IP address assigned by the DHCP server.
3. If no DHCP server is present, the FIP-1100 Streaming server will use an assigned IP
address (169.254.xxx.x).
INSTALLATION
6
FIP-1100 Manual V1.2 EN

Advertisement

Table of Contents
loading

Related Products for Fenger FIP-1100

Table of Contents