Cuckoo CWP-221 Operating Instructions Manual page 21

H H O O W W T T O O U U S S E E
R R e e h h e e a a t t / / E E v v a a p p o o r r a a t t i i o o n n o o f f c c h h l l o o r r i i n n e e
To re-boil water while warming function
is on or to evaporate the chlorine,
press the "Reheat" button, Must locate
the "Locking knob" to "Lock"
Lock
W W h h e e n n p p o o u u r r i i n n g g w w a a t t e e r r . . . . . .
After "warm" indication lamp is off,
put a cup below water
supply hole.
Next, locate the
"Locking Knob" to
"UnLock" and press
the "Push Button".
Water supply hole
W W h h e e n n t t h h e e r r e e i i s s n n o o w w a a t t e e r r i i n n i i n n n n e e r r p p o o t t . . . . . .
▶ when there is no water in the inner pot, red indication lamp and yellow
Indication lamp will blink by turns. This is to indicate the unit is over-heated, so please
disconnect the power and fill enough water, then connect power again.
What is the function of chlorine
evaporation?
It is a function that evaporates the
chlorous subatance that has been flew
in the process of purification of tap
water in the temperature at 100℃
for 2-3minutes.
If you press the "Push Button" hard
when the quantity of water in the inner
pot is little, the water may splash and
Unlock
can cause a burn.
While the unit is not in use, locate
"Locking Knob" to "Lock"
Reheat
21