Advertisement
Fueling:
Fuel tank size: 19.5 gallons
•
Fuel light comes on when the gas gets down to 2.5 gallons.
•
After pumping gas, wait 5 seconds before removing nozzle. Do not continue to add fuel after the filler
•
nozzle has automatically stopped. Additional fuel can exceed the full tank capacity.
If the fuel fill door does not open with the push-button - a manual lever is available by the read drivers
•
side door. See page 581 for instructions.
Miscellaneous Information:
Hill start assist keeps the brake engaged briefly to help prevent the vehicle from rolling on inclines as you move
your foot from the brake pedal to the accelerator.
You can lock/unlock the doors within a radius of about 32 inches of the outside door handle. You can open the
trunk within about 32 inches radius from the trunk release button.
After locking the door, wait at least two seconds before unlocking it by gripping the handle.
The 'auto lock' function is set to 'OFF' as the factory default setting. The auto lock function can be set to 'ON'
using the audio/information screen. When turned on, the auto lock function will automatically lock all doors and
the trunk when the smart entry remote leaves a 6 feet
radius of the vehicle for at least 2 seconds.
To temporarily disable the auto lock feature follow these steps:
1. Set the power mode to 'VEHICLE OFF (LOCK)'
2. Open the driver's door
3. Using the master door lock switch, operate the lock as follows: Lock > Unlock > Lock > Unlock (the beeper
sounds and the function is deactivated)
To restore the function:
1. Set the power mode to 'ON'
2. Lock the vehicle without using the auto lock function
3. Open or close the door
The security alarm continues for a maximum of two minutes until the security system alarm deactivates.
Holding the panic button on the remote will set off the truck alarm for about 30 seconds.
The power windows can be operated for up to 10 minutes after you set the power mode to VEHICLE OFF
(LOCK). Opening either front door cancels this function.
Auto Reverse: If a power window senses resistance when closing automatically, it will stop closing and reverse
direction.
The driver's window auto reverse function is disabled when you continuously pull up the switch. The auto
reverse function stops sensing when the window is almost closed to ensure that it fully closes.
Opening Windows and the Moonroof with the remote:
To open: Press the unlock button, and then within 10 seconds, press it again and hold it. If the windows and
Advertisement
