Connecting To Power - l-com L-EL9000 Quick Start Manual

Hardened Media Converter

Connecting to Power

Redundant DC Terminal Block Power Inputs or 12VDC DC Jack:
12VDC DC Jack
Step 1: Connect the supplied AC to DC power adapter to the receptacle on the topside
of the media converter.
Step 2: Connect the power cord to the AC to DC power adapter and attach the plug into
a standard AC outlet with the appropriate AC voltage.
Redundant DC Terminal Block Power Inputs
There are two pairs of power inputs can be used to power up this device. You need to
have two power inputs connected to run the media converter, but the FAULT LED
indicator will light up to remind that the power redundant system functions abnormal
in case either PWR1 or PWR2 is dead. Media Converter, however, continues working
normally even fault LED indicator lights up.
Step 1: Connect the DC power cord to the plug-able terminal block on the media
converter, and then plug it into a standard DC outlet.
Step 2: Disconnect the power cord if you want to shut down the media converter.
13