Maintenance - Konwin Home GDSFP-1500AS Owner's Manual

MAINTENANCE

1. Replacing Light Bulbs
CAUTION: Even though the glass is safety glass it may break if bumped, struck or dropped.
Care must be taken when handling the glass.
This electric stove uses clear 120V / 25W, G9 socket base light bulbs (candelabra base, B bulb).
Access the 25W bulbs through the rear access panel (see illustration below). For convenience,
replace all bulbs at the same time if one goes out.
a. Turn the main power switch off, and then unplug the power cord from the wall outlet.
b. If the stove has been operating, let the unit cool at least 1 hours.
c. Loosen the screws holding the stove back panel to the main body of stove (see Fig.1).
d. Remove light bulbs and replace with clear 120V / 25W, light bulbs (see Fig.2).
e. Place rear access panel back into position and tighten screws (Do not over tighten).
Light bulbs
Nine screws
Fig.2
Fig.1
2.Glass Information
* Under no circumstances should this product be operated with missing or broken glass.
* Do not strike or slam the glass.
* Do not use abrasive cleaners to clean the glass.
* Replacement glass is available from the manufacturer and replacement should be carried out
by a qualified service person.
3. Cleaning
*To clean the unit, first turn off controls on unit and unplug unit from power source.
*To clean the glass door: remove dust with clean dry cloth or to remove finger prints and other
marks clean glass with clean damp cloth. Do not use abrasive cleaners or spray liquids on glass door
surfaces.
*Metal and metal painted parts should be cleaned with clean damp cloth only. Do not use abrasive
cleaners or spray liquids on this surface.
7