Setting Up The Product - Jumper JPD-100S Instruction Manual

•
Mild soap and water
•
Sodium hypochlorite (chlorine bleach) (3% solution in water)
•
Quaternary ammonium compounds (such as Lysol) (10% solution
in water)
•
Do not use abrasive cleaners or strong solvents such as acetone or
acetone-based cleaners.
•
Do not use mixing disinfecting solutions (such as bleach and
ammonia) as hazardous gases may result.
•
Do not clean electrical contacts or connectors with bleach.
4.5 CLEANING INSTRUCTIONS
4.5.1 Before cleaning the product, turn the device off and disconnect the
power cord.
4.5.2 Before cleaning, remove all adherent soil (tissue, fluids, etc.) and
wipe thoroughly with a cloth dampened with water before applying
the cleaning solution.
4.5.3 When cleaning, do not immerse. Keep the exterior surface of the
device clean and free of dust and dirt, clean exterior surface of the
unit with a dry, soft cloth .if necessary, clean it with a soft cloth
soaked in a solution of soap and wipe dry with a clean cloth
immediately.
Wipe the transducer body with soft cloth to remove any remaining
coupling gel .Clean with soap only
4.5.4 Wring any excess moisture from the cloth before cleaning.
4.5.5 Avoid pouring fluids on the device, and do not allow fluids to
penetrate the exterior surfaces of the device.
4.5.6 To prevent scratching the display, the use of a soft cloth is
recommended.
CAUTION: To prevent damage to equipment, do not clean any
part of the Product or Accessories with phenolic compounds. Do
not use abrasive or flammable cleaning agents. Do not steam,
autoclave, or gas-sterilize the Product or accessories.
CAUTION: Cleaning liquids: do not submerge the device in
liquids or pour cleaning liquids over, into or onto the device.
.
14
Carefully inspect each item as it is unpacked for any signs of damage
which may have occurred during shipment.
•
Check the components according to the packing list.
•
Check for any damage or defects. Do not attempt to assemble the
product if anything is damaged or defective.
Medical Equipment Co., Limited Customer Service immediately if
anything is damaged or defective.

3.2 SETTING UP THE PRODUCT

Controls and indicators
Contact Jumper
1
2
7