Holmes HCM3955 Owner's Manual page 6

MAINTENANCE OF YOUR HOLMES®
SMART HUMIDIFIER
Water Tanks
This Smart Humidifier has two 1.87-gallon water tanks, one on each side of
the back of unit. During operation the Smart Humidifiers' right tank will empty
before the left tank starts emptying.
Removing Water Tanks From Unit
Unplug the unit from its electrical outlet
1
before removing the water tanks.
Tanks are located on the back of the unit. Remove tank slowly by pulling
2
upwards pull up the copy to connect the sentences out of appliance. Repeat
for tank on other side of unit.
3 Once tank is removed, it can be filled
through blue side tank cap. Do not
remove the bottom black plunger
assembly. This is a permanent fixture
on the tank.
Once the tank is filled, be sure the tank
4
cap gasket is seated properly and the
cap is screwed on all of the way, if not
tank cap will leak. Avoid cross-threading by properly seating the cap onto
the opening before tightening.
10
MAINTENANCE OF YOUR HOLMES®
SMART HUMIDIFIER
Placing The Water Tanks Back Into Unit
Grabbing the tank handle, gently slide tank downwards into the plunger
1
assembly on the back of the Smart Humidifier to properly set into unit.
Repeat this to replace the tank on the other side of the unit.
2
Water Notes
If you have hard water or high mineral content, this will reduce the life
of your filter, so it is recommended that you use a water treatment to
the water in the tank. For more information visit www.holmesproducts.com
or call 1-800-546-5637.
Low Water Indicator
• Your Smart Humidifier has a float switch as an indicator when the water is
low and the tanks need to be filled. When triggered, the unit's indicator will
light alerting you that the tanks need to be filled.
• The WeMo® App will also alert you when the water is low and the tanks need
to be filled.
• After the unit has indicated low water, it will run for 1 hour and then
automatically turn off. ADD WATER will flash indicating this event. The unit
will resume operation only after water has been filled.
11