Advertisement
Maintenance and Servicing
Procedures not specifically explained in this manual must
be performed only by a qualified technician.
TO PREVENT SERIOUS INJURY FROM ACCIDENTAL OPERATION:
Make sure that the Trigger is in the off-position and unplug the tool from its
electrical outlet before performing any procedure in this section.
TO PREVENT SERIOUS INJURY FROM TOOL FAILURE:
Do not use damaged equipment. If abnormal noise or vibration
occurs, have the problem corrected before further use.
Cleaning, Maintenance, and Lubrication
1. BEFORE EACH USE, inspect the general
condition of the tool. Check for:
• loose hardware,
• misalignment or binding of moving parts,
• damaged cord/electrical wiring,
• cracked or broken parts, and
• any other condition that may
affect its safe operation.
Page 12
For technical questions, please call 1-800-444-3353.
2. Immediately after use, clean the Mixing Paddle.
If the material you are mixing is water based, operate
the tool in a bucket of water. Unplug the tool,
and remove the Mixing Paddle. Wipe down the
Mixing Paddle to finish cleaning it. Spray the
paddle with light oil to prevent rust while in storage.
Then store the tool indoors out of children's reach.
3.
WARNING! If the supply cord or GFCI unit
of this power tool is damaged, it must be
replaced only by a qualified service technician.
Item 69856
Hide quick links:
Advertisement
