Task Force 21023 Operator's Manual page 9

ASSEMBLY INSTRUCTIONS
WARNING
To avoid injury, adjust the auxiliary handle for
optimum control and balance. Do not overreach when
operating the grass trimmer. Keep proper balance at
all times for better control of the tool in unexpected
situations.
1. Turn the handle lock knob (1) counter-clockwise several
turns to loosen the auxiliary handle (2).
2. Adjust the handle position to provide the best level of
balance and control for the operator.
3. Securely lock the handle in position by turning the knob
clockwise.
4. Before operating the grass trimmer, make sure the
auxiliary handle is tightly locked into position.
Cutting Line (Fig. 4 )
A spool of monofilament cutting line is preinstalled on the
grass trimmer. When the cutting line needs replacing,
insert a new spool.
To remove the spool:
1. Disconnect trimmer from the power supply.
2. Turn grass trimmer over to access the spool line.
3. Remove spool cover by pressing on two tabs parallel to
each other on the side of the cover (2).
4. Remove the spool (1) from the spool housing (3).
To replace the spool:
1. Replace the spool (1) with a new pre-wound spool.
2. Insert the end of line through the opening(4) in the spool
housing(3).
3. Align the tabs on the spool cover with the slots in the spool
housing on the trimmer head.
4. Push down on the spool cover locking it to the spool housing.
5. To advance the line when initially installed you must pull the
line while pressing the black line release button on the side
of the spool housing (3).
Fig. 3
Fig. 4
9
2
1
2
1
4
3