Table of Contents Packing List ............................. ii Section
1
M ain Components .........................3 1.1 Front View..........................3 1.1.1 Toggle Power Switch .......................3 1.1.2 Reset Button ........................3 1.1.3 Up Arrow Button, Down Arrow Button................3 ...
Packing List One (1) WebMux unit • Two (2) Power cord • One (1) WebMux User Manual • One (1) WebMux 690PG Installation Guide • One (1) Warranty registration card • - ii -...
Section 1 Main Components 1.1 Front View 1.1.1 Toggle Power Switch This switch toggles power on. To force power off, the switch must be pressed and held for 5 seconds. However, it is not recommended to use this power switch to shut down the unit. Please use the LCD panel, web interface, or command line interface to issue a proper shut down.
WebMuxes together for redundancy without following proper instructions. 1.2.3 Power Cord Please use the supplied power cord to connect the WebMux to the power source. The WebMux 690PG has a 115V/230V AC universal power supply. - 4 -...
Page 9
Section 2 Default Switch Configuration The WebMux 690 contains a built-in VLAN-enabled switch. The factory preset default VLAN ID is 4000 for the top row, and VLAN ID 4001 for the bottom row. All ports are untagged. The top row is the router LAN, and bottom row is the server LAN A user can change the router LAN and server LAN IP addresses through LCD/keypad on the front panel.
Section 3 Using swctl Command from Shell The WebMux 690 contains a built-in VLAN enabled switch. To configure this switch, please use the superuser’s command line shell command swctl. There are two ways to connect to the switch. After WebMux has booted, you may connect to the superuser’s command line either using ssh to connect on the diagnostic port or a serial connection client such as minicom using the serial port on the front of the WebMux.
Page 11
VLAN Port Add: 1. config 2. interface [port_id] 3. vlan participation include [vlan_id] 4. vlan pvid [vlan_id] 5. vlan tagging [vlan_id] VLAN Port Delete: 6. config 7. interface [port_id] 8. vlan participation exclude [vlan_id] 9. no vlan pvid [vlan_id] 10. no vlan tagging [vlan_id] Port Channel Add: 11.