AUVIO SBT4000 User Manual

SBT4000 User Manual
FRONT

Location of controls

Location of controls
TOP PANEL
Portable Turntable
BLUETOOTH
TURNTABLE
ON
OFF
MIN
BACK PANEL
SBT4000
In the box In the box
6
1. Bluetooth/Turntable switch
Portable Turntable 2. LED charging indicator light
3. LED Bluetooth indicator light
4. LED power indicator light
5. Power/Volume knob
6. RCA right speaker output port
7. RCA left speaker output port
8. USB DC 5V charging port
SBT4000
Portable Turntable User Guide
Pairing the turntable with a Bluetooth- Pairing the turntable with a Bluetooth-
enabled device enabled device
1. Turn the turntable ON.
RCA Audio USB Pin Charging 2. Move the Bluetooth/Turntable switch to the
Cable Cable Bluetooth position. The LED Bluetooth
indicator light will quickly ash BLUE.
3. Keep the turntable and Bluetooth-enabled

Charging the turntable

Charging the turntable device within 3 feet of each other during the
pairing process.
Charging via DC 5V port: 4. Set your Bluetooth-enabled device to search
for Bluetooth devices.
1. Connect the USB pin charging cable to the DC
5V charging port on the back of the turntable.
2. Connect the USB end of the USB pin charging
If a paired device is in range when the
cable into your computer or other USB charging
speaker is turned on, the speaker will
device. connect to it automatically.
3. The LED charging indicator light is GREEN when
charging. It will shut o when the turntable is On an iPhone
• Go to SETTINGS > BLUETOOTH (Make sure
fully charged.
Bluetooth is turned ON)
Make sure you charge the turntable for
at least 8 hours before using it for the
rst time.
On a Blackberry
• Go to SETTINGS/OPTIONS > BLUETOOTH
• Enable BLUETOOTH
1
Bluetooth 3G
Bluetooth:
On
Discoverable:
Yes
2 Paired Devices
Add New Device
3
SBT4000
4
5
MAX
On an Android Phone
• Go to SETTINGS > BLUETOOTH
Search for devices (Make sure Bluetooth is
turned ON)
12:12 PM
Bluetooth settings
Bluetooth
Device name
SBT4000
Visible
Make device visible
Search for devices
7 8 Bluetooth devices Scanning
On other Cell Phones/Devices
• Review the instruction manual that came
with your phone/device.
Bluetooth: Enabled
Paired Devices:
*Empty *
Searching for devices
1 found
Stop
5. When the Bluetooth-enabled device nds
the turntable, select "PBT4000" from the list
of found devices.
6. If required, enter the password 0000. Select
OK or Yes to pair the two units.
7. After a successful pairing, the LED
Bluetooth indicator light will ash BLUE
slowly.
NOTE: If you would like to connect the
speaker to another device, you must unpair
the unit from the currently paired device rst.
On your device's Bluetooth settings, select
"SBT4000, " then select "unpair. " The speaker
12:12 PM
will return to pairing mode.
Bluetooth
Bluetooth ON The screenshots above are typical of many Bluetooth-
enabled devices in the market today, and are used
Devices to assist in the explanation of the pairing process.
Your Bluetooth enabled device's interface and
SBT4000 Paired
interaction with the speaker may di er slightly
from the illustrations above.
Now discoverable
BACK

Troubleshooting Tips

Troubleshooting Tips

Using the speaker

Using the speaker

Powering ON/OFF

I can pair the Portable Turntable with my
• Turn the Power/Volume knob to the right to
Bluetooth device, but I cannot hear any music.
turn the unit ON. Turn it all the
way to the left to turn the unit OFF. 1. Make sure your Bluetooth device supports A2DP
• Check that your Bluetooth features are turned pro le.
ON. If you have already paired the turntable 2. Turn up the volume on your Bluetooth device.
with a Bluetooth enabled device, it will 3. You may have to unpair the turntable, then
automatically connect. re-pair to your device.
• If you are using the turntable for the first time, 4. Use your connected device to increase the
go to the "PAIRING THE TURNTABLE" section of volume.
this User Manual, and pair the turntable to your
desired Bluetooth device. I cannot get the Portable Turntable into
pairing mode.

Adjusting the volume

1. Make sure the Portable Turntable is turned ON
• Turn the Power/Volume knob to the left (MIN) to
before beginning the pairing process.
decrease the volume.
2. Move the Bluetooth/Turntable switch to the
• Turn the Power/Volume knob to the right (MAX)
Bluetooth position. The LED Bluetooth indica
to increase the volume.
tor light will quickly ash BLUE.
3. The turntable is now in pairing mode.
You can also adjust the volume from your
connected device's volume control.
My Bluetooth device is not able to pair with the
Portable Turntable.
Playing music Playing music
1. Make sure the Portable Turntable is turned ON
before beginning the pairing process.
To enjoy listening to music wirelessly on your
Portable Turntable make sure you are connected 2. Keep the Portable Turntable and Bluetooth
to a Bluetooth enabled device. Once connected enabled device within 3 feet of each other
press PLAY on your Bluetooth device. After during the pairing process.
playback starts, you can control the music with 3. Move the Bluetooth/Turntable switch to the
your connected device or the buttons of the Bluetooth position. The LED Bluetooth indicator
Bluetooth speaker (with devices that have the light will quickly ash BLUE.
AVRCP Bluetooth pro le). 4. Check that YOUR device's Bluetooth feature is
turned ON.

Playing vinyl records

5. Try repeating the pairing process, see "Pairing
1. Place the record on the turntable and set the the Turntable with a Bluetooth-enabled device".
needle on the record. 6. Make sure the turntable is fully charged.
2. Turn the Power/Volume knob to the right to
turn the unit ON.
3. Move the Bluetooth/Turntable switch to the
Turntable position.
Adjusting the volume
Legal information Legal information
• Turn the Volume knob to the left to decrease
the volume.
READ AND KEEP THESE INSTRUCTIONS.
• Turn the Volume knob to the right to increase
Caution: Any changes or modi cations not expressly approved
the volume.
could void the user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for a Class B digital device, pursuant to part 15 of the FCC
You can also adjust the volume from your
Rules. These limits are designed to provide reasonable protection
connected device's volume control. against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular

Using as a wired turntable

Using as a wired turntable
installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct
1. Turn the turntable ON.
the interference by one or more of the following measures:
2. Connect one red plug and white plug of the
• Reorient or relocate the receiving antenna.
included RCA Audio Cable to the corresponding
• Increase the separation between the equipment and
receiver.
right and left speaker output ports on the back
• Connect the equipment into an outlet on a circuit di erent
of the turntable.
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
3. Connect the other ends of the RCA Audio cable
for help.
to an external speaker system's input ports.
This device complies with Part 15 of the FCC Rules. Operation is
4. Open a media player on your device and click
subject to the following two conditions: (1) this device may not
on PLAY to start playing your music.
cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause
5. Use the controls on your connected device to
undesired operation.
control music playback and volume.
NOTE: The Turntable's internal speaker volume can
be increased or decreased when connected to a
Bluetooth enabled device. It will also adjust the
volume to an external speaker when connected
with the included RCA Audio cable.
Limited Warranty
90 Days Limited Warranty
In the unlikely event that this product is defective, or does
not perform properly, you may within ninety (90) days from
your original date of purchase return it to the authorized
service center for repair or exchange.
TO OBTAIN WARRANTY SERVICE:
● Call the Customer Support number located below, or go
to our website portal to receive an SRO number.
● Provide proof of the date of purchase within the package
(Dated bill of sale).
● Prepay all shipping costs to the authorized service center,
and remember to insure your return.
● Include a return shipping address (no P.O. Boxes), a
telephone contact number, and the defective unit within
the package.
● Describe the defect or reason you are returning the
product.
Your product will be repaired or replaced, at our option, for
the same or similar model of equal value if examination by
the service center determines this product is defective.
Products received damaged as a result of shipping will
require you to le a claim with the carrier.
The shipping address of the authorized service center is:
 Southern Telecom, Inc.
Attention: Customer Service (2nd Floor)
14-C 53rd Street
Brooklyn, NY 11232
Should you have any questions or problems concerning this
product, please contact our customer service department at:
Customer Support:
Phone: 1-877-768-8481
Monday-Friday 8AM-10PM(EST)
www.southerntelecom.com
Click on "Product Support"
Warranty service not provided
This warranty does not cover damage resulting from
accident, misuse, abuse, improper installation or operation,
lack of reasonable care, and unauthorized modi cation. This
warranty is voided in the event any unauthorized person
opens, alters or repairs this product. All products being
returned to the authorized service center for repair must be
suitably packaged.
Limitation of Warranty:
•
THE WARRANTY STATED ABOVE IS THE ONLY WARRANTY
APPLICABLE TO THIS PRODUCT. ALL OTHER WARRANTIES,
EXPRESS OR IMPLIED (INCLUDING ALL IMPLIED WARRANTIES
OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR
PURPOSE) ARE HEREBY DISCLAIMED. NO VERBAL OR
WRITTEN INFORMATION GIVEN BY AIT, INC. ITS AGENTS, OR
EMPLOYEES SHALL CREATE A GUARANTY OR IN ANY WAY
INCREASE THE SCOPE OF THIS WARRANTY.
•
REPAIR OR REPLACEMENT AS PROVIDED UNDER THIS
WARRANTY IS THE EXCLUSIVE REMEDY OF THE CONSUMER.
AIT, INC. SHALL NOT BE LIABLE FOR INCIDENTAL OR CONSE-
QUENTIAL DAMAGES RESULTING FROM THE USE OF THIS
PRODUCT OR ARISING OUT OF ANY BREACH OF ANY
EXPRESS OR IMPLIED WARRANTY ON THIS PRODUCT. THIS
DISCLAIMER OF WARRANTIES AND LIMITED WARRANTY ARE
GOVERNED BY THE LAWS OF THE STATE OF NEW YORK.
EXCEPT TO THE EXTENT PROHIBITED BY APPLICABLE LAW,
ANY IMPLIED WARRANTY OF MERCHANTIBILITY OR FITNESS
FOR A PARTICULAR PURPOSE ON THIS PRODUCT IS LIMITED
TO THE APPLICABLE WARRANTY PERIOD SET FORTH ABOVE.
Some states do not allow the exclusion nor limitation of
incidental or consequential damages, or limations on how
long an implied warranty lasts so the above limitations on
exclusions may not apply to you. This warranty gives you
speci c legal rights, and you also may have other rights that
vary from state to state.
Sharper Image® name and logo are registered trademarks. Manufactured
and marketed by Southern Telecom under license. © Sharper Image.
All Rights Reserved.