Summary of Contents for BrookVent Airplus
- Page 1 Positive Input Ventilation Applicable to airplus 1.1E Installation and User Maual Instructions for the Installer, Maintenance Engineer and End User airplus 1.1E Last updated 26-03-13 Page 1 of 12...
-
Page 2: Table Of Contents
PLEASE KEEP THESE INSTRUCTIONS WITH THE PRODUCT. Please read this manual fully prior to installing the PIV unit airplus Kit - Box Contents: 1 qty airplus fan unit 1 qty Thermostat 1 qty White G4 Filter 1 qty Diffuser Assembly... -
Page 3: Introduction
With the first year covering parts and labour, and the remaining 4 years covering parts only. In the instance of such a defect, Brookvent may, at its absolute discretion, repair the product, replace the product free of charge or refund the cost of the product. -
Page 4: Safety
Never touch the appliance with wet hands. • The unit is only suitable for 230 V AC/50Hz electric mains. • Never modify the fan or electronics, all repairs must be conducted by Brookvent. • Never connect the power if the electronics enclosure is open. •... -
Page 5: Technical Specification
Fan Speed Setting Specific Fan Power (w/l/s) 100% Variable Speed 0.17 100% Variable Speed 0.16 100% Variable Speed 0.17 100% Variable Speed 0.18 100% Variable Speed 0.22 100% Variable Speed 0.24 airplus 1.1E Last updated 26-03-13 Page 5 of 12... -
Page 6: Mounting
This will also ensure ease of future maintenance to the system. 4.1 Assembly & Mounting Fit Filter: To assemble the airplus unit, first take the white filter and fit over the 4 inlet spigots, as shown. The elastic should be tight and hold the filter securely in place. Mounting: The airplus 1.1 can be mounted in 2 different positions depending on requirements. -
Page 7: Ductwork And Connections
Connect the ducting to the outlet on the unit and the diffuser opening, and seal with suitable duct tape and / or sealant. airplus 1.1E Last updated 26-03-13 Page 7 of 12... -
Page 8: Electrical Connections/ Wiring
First Commissioning: Use the speed dials to set the “active” and “low” rates, approx. 20l/s and 5l/s respectively. Active: 20 l/s Low: 5 l/s airplus 1.1E Last updated 26-03-13 Page 8 of 12... - Page 9 The thermostat should be placed in the attic space near the unit itself, to measure the air temperature being drawn into the system. When the attic temperature exceeds this value the fan speed will decease to the low rate to prevent overheating of the dwelling. airplus 1.1E Last updated 26-03-13 Page 9 of 12...
- Page 10 Wiring Schematic airplus 1.1E Last updated 26-03-13 Page 10 of 12...
-
Page 11: Maintenance
Filter check for excess dust / contaminants. If the filter appears very dirty, it may • require to be changed. Contact Brookvent to purchase a spare filter. Fixings: Ensure that all of the unit fixings and the mounting fixings have not become •... - Page 12 BROOKVENT Brook House Dunmurry Industrial Estate Dunmurry BT17 9HU 028 90 616 505 02890616518 info@brookvent.co.uk www.brookvent.co.uk airplus 1.1E Last updated 26-03-13 Page 12 of 12...
Need help?
Do you have a question about the Airplus and is the answer not in the manual?
Questions and answers