Table of Contents
Advertisement
Quick Links
BUILT-IN GAS HOB
BATTERY IGNITION
THE BEAUTY OF SIMPLICITY
HB FG 3060 TN VSB
HB FG 4090 TN VSB
USER MANUAL
HB FG 4060 TN VSB
HB FG 5090 TN VSB
Model:
HB FG 3060 TN VSB [ 141252-11 ]
HB FG 3070 TN VSB [ 141253-11 ]
HB FG 4060 TN VSB [ 141250-11 ]
HB FG 4090 TN VSB [ 141251-11 ]
HB FG 5070 TN VSB
HB FG 5090 TN VSB
HB FG 3070 TN VSB
HB FG 5070 TN VSB
1
Advertisement
Table of Contents
Summary of Contents for EF HB FG 3060 TN VSB
- Page 1 Model: BUILT-IN GAS HOB HB FG 3060 TN VSB [ 141252-11 ] BATTERY IGNITION HB FG 3070 TN VSB [ 141253-11 ] HB FG 4060 TN VSB [ 141250-11 ] HB FG 4090 TN VSB [ 141251-11 ] HB FG 5070 TN VSB...
-
Page 2: Close-Up View
Congratulations on choosing our product, which you will find is dependable and easy to use. We recommend that you read this manual for best performance and to extend the life of your appliance. Thank you. Close-up View 1. Auxiliary Gas Burners 2. - Page 3 How To Use Your Appliance The position of the corresponding gas burner is indicated on each control knob. GAS BURNERS The burners differ in size and power. Choose the most appropriate one for the diameter of the cookware being used. The burner can be regulated with the corresponding control knob by using one of tile following settings: High IGNITING THE BURNERS...
-
Page 4: Cleaning And Maintenance
Cleaning and Maintenance Cleaning and maintenance should be carried out after the appliance has turned cold especially when cleaning the enameled parts. Avoid leaving alkaline or acid substances (lemon juice, vinegar etc.) on the surfaces. Avoid using acid or chlorine-based cleaning products. To extend the life of the cooktop, it is absolutely indispensable that the appliance be cleaned carefully and thoroughly on a frequent basis, keeping in mind the following: BURNERS AND GRIDS These parts can be removed and cleaned with soapy water or with non-abrasive... - Page 5 TRIPLE RING BURNER The triple ring burner must be correctly positioned (seen fig.2); the burner rib must be entered in their lodgment as shown by the arrow. The burner correctly positioned must not rotate (fig.3). Then position the cap A and the ring B (fig.3). CLEANING THE TRIPLE RING BURNER Pay special attention to this burner: the four holes around the outside of the crown must always be kept clean.
-
Page 6: Advice For The Installer
Advice for the Installer IMPORTANT: The appliance should be installed, regulated and adapted to function with other types of gas by a QUALIFIED INSTALLATION TECHNICIAN. Failure to comply with this condition will render the guarantee invalid. The appliance must be installed in compliance with regulations in force in your country and in observation of the manufacturer’s instructions. - Page 7 INSTALLATION IN KITCHEN CABINET WITH DOOR (fig.7) The fixture has to be made according to specific requirements in order to prevent the gas burners from going out, even when the flame is turned down to minimum, due to pressure changes while opening or closing the cupboard doors.
-
Page 8: Cut-Out Dimension
Distance Between Two Model (Bottom cover) (Panel) Cut Out Dimension WC X DC WP X DP HB FG 3060 TN VSB Height: 2.5-3.0mm; 563 X 483 mm 580x500 mm Width:9mm HB FG 4060 TN VSB HB FG 3070 TN VSB Height: 2.5-3.0mm;... -
Page 9: Burners And Nozzle Specifications
GAS SECTION TYPES OF GAS The gas may be grouped, in view of their features in three families: - L.P.G.(in cylinders) - NATURAL GAS(methane) - City Gas G110 Adapting the Cooktop for DifferentTypes of Gas [Table1] Burners and Nozzle Specifications G110 Burner Thermal... - Page 10 GAS CONNECTION FOR GAS HOB The Cooker should be connected to the gas-supply by licensed installer. During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenience of any subsequent removal or servicing.
- Page 11 REGULATING THE BURNER MINIMUM SETTING When switching from one type of gas to another, the minimum flow rate must also be correct. The flame should not go out even when passing suddenly from maximum to minimum flame. To regulate the flame follow the instructions below: √...
- Page 12 • Avoid touching the leaked liquid and make sure it does not come into contact with clothes or other items. • Clean the battery compartment carefully before installing the new one. • Note: The battery is a potential source of danger for children. Keep them away. •...
- Page 13 Checking the adjusted flame: heat the burner at full open position for 10 minutes. Then turn the knob into the saving setting. The flame should not extinguish nor move to the nozzle. If it goes off or moves over to the nozzle, readjust the valves.
Need help?
Do you have a question about the HB FG 3060 TN VSB and is the answer not in the manual?
Questions and answers