Setup & Initialization - ActiGraph wGT3X-BT User Manual

Setup & Initialization
This section describes how to configure the wGT3X-BT and begin collecting data.
1
2
3
4
6
Open the ActiLife software.
Connect the wGT3X-BT to the PC using the USB cable. The monitor(s) will appear in the grid under the 'Devices' tab.
Select 'Initialize'. A submenu will open to display several initialization options.
Select 'Regular Initialization' from the submenu. A dialog box will open to display the initialization parameters
listed below. The most commonly used initialization parameters are pre-selected as system defaults.
Moses (1)
Initialization Parameters
Start and Stop Times
Enter the dates and times when the device should start and stop collecting data. If no start time is selected, the
system defaults to two minutes ahead of the current time. If no stop time is selected, the device will continue
to collect data until the battery is depleted, the memory capacity is full, or it is downloaded and reinitialized.
actigraphcorp.com