ON / OFF Switch LED Flash Light OPERATION Indicator LEDs Press the switch to check the storage level of your Thunder Multi-Function Jump Starter. The indicator LEDs will flash one by one during charging. Each indicator shows level of charge. Indicator Unlit...
JUMP START 12 VOLT VEHICLE INSTRUCTION 1. Connect the blue plug firmly into the Thunder Jump Starter & make sure the cable indicator is OFF. Figure 1 2. Connect black clamp to the negative (-) battery terminal & red clamp to the positive (+) battery terminal.
1. Plug the Switch Cable B to USB 5 Volt 2 Amp output port. 2. Select appropriate connector & connect it to your mobile phone or tablet. 3. Turn the Thunder Jump Starter ON to charge device. Power Supply to 12 Volt Products 1.
PARTS LIST Supplied in a handy Carry Case - Total Weight 1.5kg Size: 230mm(L) x 87mm(W) x 27mm(H) Thunder Jump Starter Weight: 615g 240 Volt Charger Input: AC / 100 Volt - 240 Volt, Output: DC / 14 Volt 1 Amp...
• Always make sure the blue plug of jumper cable is secure in the Thunder Jump Starter before starting. A. Your Thunder Jump Starter will power OFF automatically when there is no load or charging is complete. • Always check if the jumper clamps are well connected.
WARRANTY, TERMS & CONDITIONS When you acquire or fit a Thunder product you have the peace of mind in knowing that it is backed by a comprehensive 12 month warranty against defects in materials & workmanship. The Thunder warranty is provided in additional to any rights you may have under the Australian Consumer Law.
Need help?
Do you have a question about the Multi-Function Jump Starter and is the answer not in the manual?
Questions and answers