Page 1
PLEASE READ AND SAVE THESE INSTRUCTIONS DOUBLE MOTOR PET DRYER OWNER’S MANUAL MODEL: B-27 (115V/60Hz) XPOWER MANUFACTURE, INC. 220 Clary Avenue Nozzles San Gabriel, CA 91776, USA included Tel: 626-285-3301 Fax: 626-285-3302 www.xpower.ws...
TABLE OF CONTENTS Introduction ............................Operation ............................Specifications ............................Important Safety Instructions ......................Save These Instructions ........................Parts List ............................. Maintenance ............................Warranty / Service ..........................Warranty Registration Form .......................
INTRODUCTION The XPOWER B-27 Professional Double Motor Pet Dryer is the first addition to our new XPOWER X-TREME Line. Much like the B-5, the B-27 X-TREME Blaster was designed to be extremely quiet, lightweight and powerful. This 6HP double motor blaster provides 3x the power to dry pets quickly while saving you time–...
OPERATION 1. Place the dryer on a flat surface. Plug the electrical cord into a 3-prong GFCI outlet. 2. Connect the hose to the front hose connector and attach the desired nozzle. Turn on switch to desired speed. It is necessary to close the Bleed hole on hose while drying. 3.
SAFETY INSTRUCTIONS WARNING: IMPORTANT SAFETY PRECAUTIONS! When using electrical appliances, especially when children or animals are present, basic safety precautions should always be followed to reduce the risk of fire, electric shock, and personal injury, including, but not limited to the following: •...
SAVE THESE INSTRUCTIONS HOUSEHOLD and COMMERCIAL USE GROUNDING INSTRUCTIONS This appliance must be grounded. In the event of malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce the risk of electric shock. This appliance is equipped with a cord having an equipment-grounding conductor and a grounding plug.
PARTS LIST Left Housing Motor 15 Crossed cover Right Housing Motor rubber sleeve 16 Inlet filter Switch 10 Dustproof cover 17 Hose Air outlet grid 11 Motor filter 18 Round groomer rake Motor rubber sleeve 12 Dust case 19 Cone nozzle PCB board 13 Dust case filter 20 Flat nozzle...
Cleaning Dryer Dust Case, Rear Cover and Filters: The Filter System for the XPOWER B-27 Pet Dryer (including dust case, rear cover and filters) should be kept clean regularly. If the dust case is full of dirt or the filters become heavily coated, the air output and input of your Dryer will reduce and this can cause damage to the motors or cause the motors to overheat.
Page 9
1.Turn the rear cover 2.Take the complete set of dust 3.Dump the dirt out of the counter-clockwise to case and rear cover out of the dust case. remove the cover. unit. Keep the rear cover on top so that the hair and dirt are in the dust case.
The liability of XPOWER is limited solely to the cost of the repair or replacement of the unit at XPOWER’s discretion. This warranty does not cover normal wear of parts and does not apply to any unit that has been tampered with or used for commercial purposes.
WARRANTY REGISTRATION Please complete and mail or fax for your product warranty. For multiple units, please list serial numbers on a separate sheet of paper. Address: XPOWER MANUFACTURE, INC. 220 Clary Avenue San Gabriel, CA 91776, USA Tel: 626-285-3301, Fax: 626-285-3302...
Page 12
From: XPOWER MANUFACTURE, INC. 220 Clary Avenue San Gabriel, CA 91776, USA Tel: 626-285-3301, Fax: 626-285-3302...