Summary of Contents for Presto PM-10
- Page 1 PM-10 PM-20 PM-30 PRESTO MIXER MANUAL FOR OPERATOR-DO NOT DISCARD VER. 2016-01 www.mvpgroupcorp.com 1 888-275-4538...
- Page 2 Warranty will be performed by an Authorized Designated PRESTO Service Location during normal working hours. In no event shall presto be liable for incidental or consequential damages to buyer or any third party, including, without limitation, loss of property, personal injury, loss of business or profits or other economic losses, or statutory or exemplary damages, whether in negligence, warranty, strict liability, or otherwise.
-
Page 3: Installation Notes
Doing so my create hazards and will void warranty. DO NOT attempt to lift the mixer alone. PM-10 & PM-20 The outlet must be 110 Volts and 15 Amps. It should be on a dedicated circuit, and the electrical installation should be grounded. The circuit breaker protecting this line should be adequately sized to protect the wires. - Page 4 PM-10 Emergency Stop Button PM-20 Start Button Speed Lever Bowl Lift Safety Cage ATTACHING THE BOWL TO THE MIXER NOTE: Install the bowl BEFORE attaching the agitators. 1. Lower the bowl by pulling the bowl lift lever forward and down to its resting position 2.
-
Page 5: Mixing Ingredients
1. Add the appropriate mixing ingredients into the bowl. 2. Lift completely up on the bowl lift lever until the bowl locks into position. 3. Rotate (PM-10, PM-20) or pull down (PM-30) the bowl guard so it is into the closed position. A clicking sound will be heard. - Page 6 IMPORTANT: When mixing product always follow the recommended agitator and speed setting according to the capacity chart of this manual. Make sure the emergency switch is not engaged by either pushing(PM-10, PM-20) or turning and pulling it (PM-30). Press the green start button located on the middle of the control panel.
-
Page 7: Helpful Hints
MEAT GRINDER AND VEGETABLE ATTACHMENTS HOW TO USE 1. Before first use, wash all parts of Meat Grinder or Vegetable Shredder. 2. Make sure the On/Off Switch is in the Off position. 3. Secure attachment properly in the mixer hub (figure 1). 4. -
Page 8: Cleaning Instructions
Cleaning instructions Always clean the mixer after every use Never use pressured water to clean the mixer Agitator attachment must be removed and cleaned daily. Always disconnect the mixer when cleaning Use soap and water with a plastic brush and rag. The lifting mechanism should be kept cleaned and lubricated with mineral oil only as required.
Need help?
Do you have a question about the PM-10 and is the answer not in the manual?
Questions and answers