CHOFU GF-200L User And Technical Manual

Propane water heater

Advertisement

USER / TECHNICAL MANUAL
CE0598
598BP163
Country:
DK, FI, NL, NO, SE
Category:
I 3 B/P
Gas Pressure:
Propane 30 mbar, Butane 30 mbar
Model: GF-200L
CHOFU GF-200L
Propane Water Heater
Marketing:
SpaDealers - Korsnäs - Finland
+358 10 2395600
info@spadealers.fi
-
www.spadealers.eu
Manufacturer
CHOFU SEISAKUSHO CO., LTD., JAPAN
WARNING
Read the technical instructions before installing the
appliance
Read the users instructions before lighting the appliance
Any interference with a sealed component is forbidden
Incorrect use may be dangerous
Accessible parts may be very hot. Keep young children
away
For outdoor use only

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the GF-200L and is the answer not in the manual?

Questions and answers

Odin Brudie
July 12, 2025

I have a Chofu GF-200L propane self circulating hot tub heater. The Igniter switch is broken. Can I find a replacement? Thank you. Odin Brudie, (907)209-4344.

Summary of Contents for CHOFU GF-200L

  • Page 1 Accessible parts may be very hot. Keep young children Gas Pressure: away Propane 30 mbar, Butane 30 mbar • For outdoor use only Model: GF-200L Marketing: SpaDealers - Korsnäs - Finland +358 10 2395600 info@spadealers.fi www.spadealers.eu Manufacturer CHOFU SEISAKUSHO CO., LTD., JAPAN...
  • Page 2 Chofu Propane gas heater The Chofu Propane gas heater is a highly efficient water heater especially designed for Hot Tubs. The water is self circulating, using the "thermosiphon" principle. Hot water rises and creates low pressure, which sucks the water from below. This eliminates the need for a circulation pump and electricity, making it possible to heat the water with the heater placed on the outside.
  • Page 3 OBSERVE! If you are the least bit unsure about installing the gas heater then you should let a professional handle the installation of the heater. A special remote control makes it possible to control the Chofu Propane gas heater also from inside the house or from a distance. The remote control can be installed for a “wall thickness”...
  • Page 4 Ignition 1. Turn the switch from position [0] to [1], to start the ignition in the control burner. 2. Keep the switch in that position for approx. 10-20 seconds until the ignition indicator lamp (L) turns red. 3. Turn the switch (K) to position [2] and then directly to position [3].

Table of Contents