Table of Contents
Advertisement
- Do not use any solvents or cleaning materials when cleaning the video system.
- Do not use any abrasive cleaners, they may scratch the screen. Use only a lightly dampened
lint free cloth to wipe the screen if it is dirty.
- Lock the LCD screen in the fully closed position when not in use.
- Before putting on headphones always adjust the volume setting to the lowest position.
- Remember to leave the dome light switch in the off or auto position when the vehicle is
unattended, as the dome lights, if left on, can drain the vehicle battery.
- Do not put pressure on the screen.
- Caution children to avoid touching or scratching the screen, as it may become dirty or
damaged.
(Q1) IR Sensor Inoperative
(1) Verify that the batteries in the remote are installed correctly and in good condition.
(2) Verify that the remote sensor eye is not obstructed.
(3) Verify that the infrared transmitter is affixed over the sensor eye of the component to be
controlled.
(Q2) No Picture
(1) Verify that the correct video input mode is used on the monitor.
(2) Verify that the video cables are securely connected.
(Q3) No Sound
(1) Verify that the correct audio input mode is used on the monitor.
(2) Verify that the audio cables are securely connected.
(Q4) Message "No Signal"
(1) It is not possible to have both units switch to Crosslink at the same time.
(2) Change source again to switch to a proper function.
Warnings
Troubleshooting
11
Hide quick links:
Advertisement
Table of Contents
