Subscribe to Our Youtube Channel
Summary of Contents for Sherpa ST-MT340
- Page 1 OPERATOR’S MANUAL ST-MT340 MULTI-TOOL IMPORTANT! IT IS ESSENTIAL THAT YOU READ THE INSTRUCTIONS IN THIS MANUAL BEFORE ASSEMBLING, OPERATING AND MAINTAINING THIS MACHINE.
-
Page 4: Warning Labels On The Machine
WARNING LABELS ON THE MACHINE Never modify your machine. The warranty is void if you make any modification to the machine or if you do not observe the proper usage guidance written in this manual. For safe operation and maintenance, symbols are de-bossed into the machine. Observe these markings and the associated instructions in this manual for safe operation. -
Page 5: For Safe Operation
FOR SAFE OPERATION stored fuel FOR SAFE OPERATION ’... - Page 6 FOR SAFE OPERATION...
- Page 7 FOR SAFE OPERATION authorised petrol.
- Page 8 FOR SAFE OPERATION...
- Page 9 SET UP Mount the handle between the harness attachment point and the end of the main shaft at a position comfortable for the user. Insert and tighten bolts supplied to secure the handle to the shaft in the desired position. Ensure the secondary grip of the handle is on the left of the shaft and in the direction as per the arrow on the grip.
- Page 10 SET UP While holding the unit by your right hand securely, pull the end of the red fabric tab upwards, away from the machine (to pull the metal retaining bar out of the buckle). The clip will separate from the harness leaving the unit unattached.
- Page 11 SET UP...
- Page 12 SET UP...
-
Page 13: Fuel And Chain Oil
FUEL & CHAIN OIL Petrol is very flammable. petrol petrol in the container. PETROL 40 : OIL 1 PETROL petrol. petrol Unleaded petrol is recommended to reduce the contamination of the air for the sake of your health and the environment. Poor quality petrol or oil may damage the sealing rings, fuel lines or fuel tank of the engine. -
Page 14: Operation
OPERATION Set the on/off switch (1) to on (-) position. Ensure the choke lever (CL) is in the CHOKE position. Prime the engine 5-10 times by pushing the down on the primer bulb firmly (PB). (PB) (CL) Place the unit on a flat, firm surface. Keep the (SH) cutting head clear of anything around. - Page 15 OPERATION...
- Page 16 OPERATION light growth will.
- Page 17 OPERATION...
- Page 18 OPERATION...
- Page 19 OPERATION...
- Page 20 OPERATION Stop the engine. Pull the pin (1) out. Whilst holding the pin (1), pinch together two levers (2,3) together to free the head movement.You can now release the pin (1). Holding the levers (2,3), move the handle (4) to adjust the angle of the blades.
- Page 21 OPERATION...
-
Page 22: Maintenance
MAINTENANCE... - Page 23 MAINTENANCE...
- Page 24 MAINTENANCE (1) Intake Air Cooling Vent (Back)
- Page 25 MAINTENANCE...
- Page 26 MAINTENANCE...
- Page 27 MAINTENANCE...
-
Page 28: Troubleshooting Guide
DISPOSAL TROUBLESHOOTING GUIDE... - Page 29 PARTS - ENGINE...
- Page 30 PARTS - HEDGE TRIMMER ATTACHMENT...
- Page 31 PARTS - POLE PRUNER ATTACHMENT...
- Page 32 PARTS - BRUSHCUTTER ATTACHMENT...
- Page 33 PARTS - MAIN UNIT...
- Page 36 CONTACT Sherpa Tools Ltd. ST-MT340 MULTI-TOOL If you experience any problems with this product, please do not return to the store. Contact Sherpa Tools direct on our UK helpline. UK Helpline: 01522 283 020 www.sherpatools.co.uk May 2016...
Need help?
Do you have a question about the ST-MT340 and is the answer not in the manual?
Questions and answers