Advertisement
MAX RANGE ON/POWER OFF/ATTEN ON: This multipurpose 3-position switch turns
the power on and off. It also operates the attenuator, needed when your receiver is
being swamped by the animal's beeping signal.
When the switch is in the MAXimum RANGE ON position, the receiver power is
turned on and the attenuator is off to give best long distance tracking.
When the switch is in the ATTENuator ON position, the receiver power is turned on
and the attenuator is on for best close-in tracking.
When the switch is in the center POWER OFF position, the receiver power is
turned off to save battery.
GAIN: Sets receiver volume; turn clockwise for more volume; turn counterclockwise for
less.
TUNE: Fine-tunes each 10 KHz channel. O (zero) position marks the channel center. -5
and +5 are marks to show plus and minus 5 KHz from center frequency.
CHANNEL: Ten-position channel switch allows selection of the desired frequency
number. See list of channels/frequency ranges on top of receiver.
SIGNAL METER: Enhances direction and location finding by allowing comparison of
signal with the beeping sound coming from transmitter. The sensitive needle deflects to
match transmitter collar's sound. The stronger the signal, the more the needle is moved
to the right with the beep.
INFORMATION about CONTROLS at BACK of receiver:
ANTENNA JACK: (at lower back) accepts antenna's BNC Connector with 50-ohm coax
cable
DUAL PURPOSE DC EXTERNAL POWER JACK and RECHARGER JACK: (at upper
back) allows receiver to be operated by DC power cord from vehicle cigarette lighter
plug-in. Also insert recharger plug here for recharging NiCad batteries.
1. To turn on receiver, push toggle switch UP to Max(imum) Range On. For battery
conservation, turn the receiver OFF by pushing the toggle switch to central POWER
OFF position after you have located your animal's signal. The TRX-10S Receiver will
automatically be powered by rechargeable NiCad batteries.
If you wish to power the receiver from a vehicle, insert the DC power cord's male plug
into the DC External Power Jack at the upper back, then insert other end of DC Power
Cord into vehicle cigarette lighter. The toggle switch on receiver face can be pushed up
to MAX RANGE ON or down to ATTEN. ON position.
2. As your transmittered animal moves a distance away, a directional antenna will be
needed to locate and magnify the animal's signal. To use the antenna, attach its cable
BNC Connector to the receiver jack at the lower back. Fit the BNC Connector, push in
OPERATING INSTRUCTIONS:
Advertisement
