Maintenance & Troubleshooting Guide - MX-Select MX55 Owner's Manual

MAINTENANCE & TROUBLESHOOTING GUIDE
For full product support, manuals and warranty requests visit: www.MXSelect.com/support
PROBLEM
When the handset
is lifted out of its
cradle an extra
weight plate lifts
out and becomes
dislodged from the
remaining weight
plate stack.
The weight selector
dial feels too tight
and does not turn
smoothly.
The stand seems
to be loose
To ensure maximum lifespan and optimal performance follow these steps:
1. Keep your dumbbells in a dry, clean climate controlled environment at room temperature.
2. Periodically clean your dumbbell plates and handset with disinfectant, applied using a lint free cloth.
3. Keep dust off the system.
4. ARMOR ALL protectant will give your system a beautiful clean and shine.
5. Periodically examine your product for damage, if repairs are required refer to the MX Select website
for information on how to service your handset and purchase spare parts. Only manufacturer supplied
components can be used to maintain and repair the equipment under warranty.
6. Periodically shuffle the weight plates.
7. Store and operate your MX55 system on level ground.
8. Periodically check that the bolts on the system are tight.
SOLUTION
TIP: Be sure to lift the dumbbell vertically when removing it from the cradle.
If the dumbbell is pulled out at an angle, it may drag against un-selected
weight plates.
The cradle end plate is too tight. Loosen the four bolts beneath the cradle at
one end. The four holes are slotted for the purpose of adjusting the cradle
length. With the cradle end loose, place the fully loaded dumbbell in and out
of the cradle several times. It will self-adjust to the proper setting. To test,
select 35 lbs and lift the dumbbell out quickly and see if the rest of the plates
remain in place without "sticking".
Check the surfaces between weight plates to make sure they are clean and
free of debris*.
The weight plates should slide together easily with little resistance. Also check
the tabs on the weight plates to ensure they are not bent or broken from
accidental misuse. If so, replace any damaged weight plates.
Check to ensure you have released the weight selector dial fully by pressing
the release button. If not fully released the locking mechanism could be
hindering the dial from turning.
Adjust cradle end plate as described above.
Check to see if stand is on a firm, level surface.
Shuffle the weight plates around.
Tighten the bolts. If bolts have cross threaded or stripped, please contact
your dealer for replacements.
11