Advertisement
WARNING
Due to reduced ground clearance remove plow Mount Brackets before trail riding.
Do not exceed 5 MPH with the blade or its brackets installed
♦ Periodically check for wear and tightness of all bolts, nuts and
fasteners. Replace or tighten as necessary
All directions referring to the right and the left are when the
operator is sitting on the ATV.
Attaching Bracket Installation Instructions
1. Using the four 5/16" x 1" Carriage Bolts (#5) secure the Bracket Straps (#3) and the Support
Bars (#2) to the Attaching Bracket (#1). See Parts Breakdown. Position the Support Bars
toward the front of the machine and angled slightly toward the center. Do Not tighten
Carriage bolts at this time.
2. Remove the Bolts from the foot pegs; retain bolts for use when Attaching Kit is not installed.
Position the Attaching Bracket against the mainframe tubes directly under the foot pegs.
Using the Provided 8 x 30mm Bolts, attach the Bracket Straps to the foot peg. Tighten Fully.
3. Using the two 5/16" x 1 1/4" x 2" U-Bolts (#5) secure the two Support Bars (#2) to the
ATV's outside mainframe tubes. Do not over tighten the U-bolts, damage to frame may
occur. Tight Carriage Bolts fully at this time.
Left Side Shown
4
Advertisement
