1. Manuals
  2. Brands
  3. Simple Control Manuals
  4. Remote Control
  5. Simple Blaster Wi-Fi
  6. Setup manual

Simple Control Simple Blaster Wi-Fi Setup Manual

Hide thumbs
1
2
3
4
5
6
7
8

Advertisement

Table of Contents

Simple Blaster
Wi-Fi
™
S E T U P G U I D E
Simple Blaster
™
Wi-Fi
This document describes how to
set up Simple Blaster - Wi-Fi.
Released October 2015. Copyright ©2015 by Roomie Remote, Inc. All Rights Reserved. SimpleControl.com

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Simple Blaster Wi-Fi and is the answer not in the manual?

Questions and answers

Summary of Contents for Simple Control Simple Blaster Wi-Fi

  • Page 1 Simple Blaster Wi-Fi ™ S E T U P G U I D E Simple Blaster ™ Wi-Fi This document describes how to set up Simple Blaster - Wi-Fi. Released October 2015. Copyright ©2015 by Roomie Remote, Inc. All Rights Reserved. SimpleControl.com...
  • Page 2 Reset Cables Power CABLES The Simple Blaster works with: • Simple Cable - Complete: Has two emitters and one blaster; must connect directly to the Simple Blaster. Affix emitter directly over the infrared port on the target device. Position the blaster to target devices by line of sight.
  • Page 3 Simple Blaster Wi-Fi ™ Emitters Blaster Control one Controls many device each devices by line of sight • Simple Cable - Triport Adapter: Supports three emitters or two emitters and one blaster; must connect directly to a Simple Blaster. Used only with single cable accessories. Separate purchase.
  • Page 4 CONFIGURATION This procedure assumes the Simple Control app is installed on your iOS device and that you are using the included Simple Cable - Complete. To set up a Simple Blaster - Wi-Fi: Find appropriate locations for the Simple Blaster and cables, then apply power to the Simple Blaster.
  • Page 5 Close the web browser on your wireless device, then switch it back to your home network (from the ad-hoc network). Open the Simple Control app, edit a room, and tap Add Device. On the Add Device screen, verify that Simple Blaster WiFi appears.
  • Page 6 Tap Flex Link Cable, then select Infrared as the Flex Link Cable Mode on the Flex Link Cable screen. Because you are using a Simple Cable - Complete, set Three IR Port Flex Link Cable to Yes. If the Simple Cable - Complete is controlling devices via the blaster, set Blaster to Yes.

  • Page 7: Troubleshooting

    IR Port 3, and check the line of sight for any device that is being controlled via a blaster. If you are experiencing other infrared issues with a target device, refer to the infrared device section of the Simple Control FAQ.
  • Page 8 Questions? Contact Us. support@simplecontrol.com SimpleControl.com Simple Control 21580 Stevens Creek Blvd. Suite 106 Cupertino, CA 95014 Released October 2015. Copyright ©2015 by Roomie Remote, Inc. All Rights Reserved. SimpleControl.com...

Table of Contents