All copies of the technology and related information, if allowed by ATS, must display this notice of copyright and ownership in full. AssureID™, Reveal-ID™ and i-Dentify™ are trademarks of AssureTec Technologies, Inc. Certain product, service, or company designations for companies other than ATS may be mentioned in this document for identification purposes only.
ID-100 and ID-150 User’s Guide Features The ID-100 and ID-150 Desktop Document Scanners have the following features: High resolution (600 dpi) double-sided color card scanner High-speed scan and transfer of images within 5 seconds Plug-and-play connectivity with high-speed USB 2.0 interface ...
USB cable with ferrite core External power supply 4.2. System Requirements The system requirements for the ID-100 and ID-150 document scanners are listed below: Microsoft Windows XP (SP2 or greater), Windows Vista, or Windows 7 operating systems (32- or 64-bit) ...
Page 7
Windows XP Driver Install Warning Windows Vista Driver Install Warning 3. Once the installation has completed, connect the ID-100 or ID-150 to the computer’s USB port, plug the scanner in, and then power it on. The driver will automatically be...
Page 8
4. When the hardware installation has completed, a message will be displayed indicating that the device is ready for use. 5. The ID-100 or ID-150 document scanner is now ready for use. To confirm that the device drivers are properly installed, verify that the device is present in Device Manager (accessible from the Control Panel), as shown below: AssureTec Technologies, Inc.
ID-100 and ID-150 User’s Guide Rear Panel The rear panel of the document scanner is shown below (ID-100 is shown): Power 12VDC Switches The table below describes the purposes of the DIP switches. DIP switches should not be changed from the default position except for cleaning (#3) or if instructed by AssureTec Support personnel.
ID-100 and ID-150 User’s Guide Status Indicators The ID-100 and ID-150 document scanners have two LED status indicators on the front left surface. LED1 LED2 Name Purpose LED1 USB status / scan ready LED2 Power status The state of these LEDs will indicate the current status and assist in troubleshooting problems.
ID-100 and ID-150 User’s Guide Cleaning Regularly scheduled cleaning of the scanner is recommended to ensure that the device feeds documents smoothly and delivers good quality images. The following components require cleaning according to the specified maintenance schedule: Component Recommended Maintenance Interval...
3. Using a cleaning wipe or alcohol prep, clean the white CIS (scan head) bars on the top and bottom of the unit and then discard the wipe when done. There are two CIS bars on the ID-100 and three on the ID-150. 4. Close the cover.
ID-100 and ID-150 User’s Guide 7.3. Cleaning the Magnetic Stripe Reader (ID-150 only) Over time, the magnetic stripe reader will require cleaning to remove buildup and to ensure proper operation and accurate reads of magnetic stripes. To clean the magnetic stripe reader, follow the steps below: 1.
ID-100 and ID-150 User’s Guide Removing a Jammed or Stuck Card If a card becomes stuck inside the scanner, it may be easily removed by lifting the cover and sliding the card out of the scanner. Once removed, the cover can be closed and the scanner should resume normal operations.
ID-100 and ID-150 User’s Guide Customer Support If you purchased your equipment directly from AssureTec, please contact Customer Support for technical support or warranty-related issues. If you purchased your equipment from one of our partners or resellers, please contact the reseller for support or warranty-related service.
Need help?
Do you have a question about the ID-100 and is the answer not in the manual?
Questions and answers