Thank you for purchasing our product. If there are any questions, or requests, please do not hesitate to contact your distributor. This manual applies to the SmartWatch H20IPSD302 & H20IPSDIR302 IP PTZ dome cameras. This manual may contain several technical incorrect places or printing errors, and the content is subject to change without notice.
SmartWatch® IP PTZ Dome Cameras·Quick Start Guide Safety Instruction These instructions are intended to ensure that user can use the product correctly to avoid danger or property loss. The precaution measure is divided into Warnings and Cautions: Warnings Follow Cautions Follow these...
SmartWatch® IP PTZ Dome Cameras·Quick Start Guide 1 Overview 1.1 Check package contents Before you start: Check the package contents and make sure that the device in the package is in good condition and all the assembly parts are included.
Remove Rear Cover Micro SD Card Slot Figure 1-2 Micro SD Card Slot H20IPSD302: The micro SD card slots of the H20IPSD302 are shown below. Refer to the following steps to install the micro SD card. Steps: 1. Loosen the two lock screws on the edge of the lower dome and remove the lower dome.
Page 7
SmartWatch® IP PTZ Dome Cameras·Quick Start Guide Protective Sticker Protective Foam Figure 1-4 Remove the protective foam H20IPSDIR302: The micro SD card slot is inside the rear cover. Refer to the following steps to install the micro SD card.
SmartWatch® IP PTZ Dome Cameras·Quick Start Guide 2 Installation Warning: Do not power the up speed dome until the installation is finished. For safety, all the installation steps should be completed with power supply off. For details of the installation flow(described in the section 2.4), please refer to the following sections.
SmartWatch® IP PTZ Dome Cameras·Quick Start Guide Figure 2-2 Drill Screw Hole and Insert Expansion Screw 3. Secure the wall mount with 4 hex nuts and washers. Figure 2-3 Drill Screw Holes Note: Please use water-proof measures when installing outdoor speed domes.
Page 10
SmartWatch® IP PTZ Dome Cameras·Quick Start Guide Safety Rope Figure 2-4 Safety Rope 2. Loosen the lock screws on the wall mount as shown below. 3. Align the speed dome with the wall mount bracket and rotate it counterclockwise or clockwise to the mount tightly as shown below.
Page 11
SmartWatch® IP PTZ Dome Cameras·Quick Start Guide Figure 2-6 Tighten the Lock Screws H20IPSDIR302 Installation Steps: 1. Remove the protective sticker from the speed dome. Protective Sticker Figure 2-7 Remove Sticker 2. Hook the safety strap to the back box of the speed dome and the wall mount bracket. Route the cables through the mount as shown below.
Page 12
SmartWatch® IP PTZ Dome Cameras·Quick Start Guide Lock Screw Safety Rope Push Rotate Figure 2-8 Align to the Mount 5. Use the Allen key to tighten the lock screws to secure the speed dome and the wall mount. Figure 2-9 Tighten the Lock Screws...
Need help?
Do you have a question about the H20IPSD302 and is the answer not in the manual?
Questions and answers