Table of Contents
Summary of Contents for KERN YBI-01
-
Page 1: Operating Manual
KERN & Sohn GmbH Ziegelei 1 Phone: +49-[0]7433- 9933-0 D-72336 Balingen Fax: +49-[0]7433-9933-149 email: info@kern-sohn.com Internet: www.kern-sohn.com Operating Manual Ionizer KERN YBI-01 Version 1.0 05/2008 YBI-01-BA-e-0810... -
Page 2: Ybi-01-Ba-E
YBI-01-BA-e-0810... -
Page 3: Table Of Contents
KERN YBI-01 Version 1.0 05/2008 Operating Manual Ionizer Table of Contents GENERAL ....................... 4 BASIC SAFETY PRECAUTIONS..............4 TECHNICAL DATA ..................7 APPLIANCE OVERVIEW................7 UNPACKING, SETUP AND COMMISSIONING..........8 Unpacking ..........................8 Placing ............................8 Mains connection ........................10 COMMISSIONING .................. -
Page 4: General
LED starts glowing, turn off the ionizer immediately and disconnect it from the mains. If water or other foreign matter enters the ionizer, turn off the master switch immediately and disconnect it from the mains. YBI-01-BA-e-0810... -
Page 5: Ionizer
Risk of injury! The peaks of the ion source are sharp and cutting. The ionizer generates poisonous ozone; ensure sufficient ventilation. For maintenance and repair work disconnect the ionizer from the mains. Disconnect the ionizer from the mains during periods of idleness. YBI-01-BA-e-0810... - Page 6 The ionizer may heat up slightly during operation. Prior to ionising powdery goods to be weighed, turn off the fan. Ionisation results are better when the fan is turned on and the period required for discharging the sample will be shortened. YBI-01-BA-e-0810...
-
Page 7: Technical Data
LED Ionizer operation (green = normal operation, red = breakdown) LED fan operation (blue = on) Fan on- and off-switch Knob for setting height / angle of inclination Main switch 10. Mains adapter connection 11. Knob for permanent fixing of ionizer YBI-01-BA-e-0810... -
Page 8: Unpacking, Setup And Commissioning
(4) Operating instructions Placing The ionizer may be used as a desktop or hand-held device. Using it on a desktop Position knob (1) and tighten it by turning. Insert the ionizer into the V-shaped recess (2a 2b), ensuring a good fit YBI-01-BA-e-0810... -
Page 9: Ionizer
(3). Use the knob on the frame to set the height and angle of inclination. Using it as a hand-held device To use it as a hand-held device, remove the ionizer from the frame as illustrated. YBI-01-BA-e-0810... -
Page 10: Mains Connection
Power is supplied via the external mains adapter. The stated voltage value must be the same as the local voltage. Only use original KERN mains adapters. Using other makes requires consent by KERN. Turn off the ionizer (master switch “OFF“) before connecting it to the mains adapter. -
Page 11: Applications
Discharge of beakers etc. Powdery samples are deposited at the inner wall of the glass when being poured into the beaker. This is prevented by discharging the beaker. Use as hand-held device outside the weighing chamber. YBI-01-BA-e-0810... -
Page 12: Service, Maintenance, Disposal
Maintenance Service The appliance may only be opened by trained service technicians who are authorized by KERN. Before opening, disconnect from power supply. Disposal Disposal of packaging and appliance must be carried out by operator according to valid national or regional law of the location where the appliance is used.
Need help?
Do you have a question about the YBI-01 and is the answer not in the manual?
Questions and answers