Page 2
5. Run the application on the terminal. Your System Administrator will instruct you how to do this. NOTE: When using the RF link device, be sure to put your hand through the safety strap before grabbing the handle. Inserting/Removing the Terminal To insert the terminal into the RF link device: 1.
Page 3
Linking the RF Modules Despite there being no physical connection (a cable), the RF link device and printer must still be linked so they can communicate. To set up the link: 1. Turn off the RF link device, printer, and terminal. See the documentation for the terminal and printer for more information.
Page 4
When you have linked the modules, they can talk with each other up to 20 feet apart. NOTE: When you are not using the printer, terminal, and RF link device, be sure to turn them off. S c a n n i n g B a r C o d e s To scan a bar code: 1.
Page 5
U s i n g a C a b l e C o n n e c t i o n Optional. You do not necessarily have to use the RF link device with RF communications. You can connect the RF link device to the printer with a cable (part number 12029351).
Page 6
T r o u b l e s h o o t i n g Problems can occur with the scanner and RF communications. Scanner Problems If the scanner does not turn on, have your System Administrator check ♦ the terminal’s application to determine if it initializes the scanner in the form’s activate event.
Page 7
RF Communication Problems If the RF link device and the printer are not communicating, try each of these suggestions to correct the problem. ♦ Change or recharge the terminal’s battery. ♦ Have your System Administrator ensure that the following communication parameters are set on both the terminal and the printer: −...
This manual is also suitable for:
Monarch ppt 2800Monarch tc7400troiMonarch rf link with trigger 7400