How To Diagnose The Amplifier Section - Pioneer VSX-1015TX-S Service Manual

5

7.1.2 HOW TO DIAGNOSE THE AMPLIFIER SECTION

QQ
3 7 63 1515 0
When DC detection worked (MCACC LED flashes for a long
time) in the protection circuit of foregoing section (or there is not
the speaker output, probably only 1CH), failure (damage) of the
power amplifier section is considered.
Because this receiver cannot diagnose the amplifier section by an
electricity state by structure, please diagnose it in the following
steps.
Caution:
When release the STBY (MCACC LED flashes) state before
repair, Because there is the case that the damage progresses when
turns the power on once again, please be careful.
• According to a symptom, perform the following
confirmation beforehand.
1. Are not Fuse and IC protector opening it?
2-a. When can turn on electricity, confirm that supply voltage of
the point that can measure is appropriate.
2-b. Furthermore, confirm that voltage ((in a no signal) DC and
the appropriate signal output) between GND and R2008-
R2014 on the SP/PS Assy (Either of the amplifier side and
the speaker terminal side is possible) (Or remove either of
CN2101-2104) on the SP/PS Assy. And limit failure CH.
If was able to limit failure CH, diagnose the CH in the following
steps.
• Use the tester basically and check that each part is
not damaged (resistance value / open / short circuit).
TE
L 13942296513
About parts with damaged possibility, explain FL ch to an
example in order.
1. R4231, R4232 (ACN7132: 0.047 Ω, 0.5W chip drain resistor)
IC 4202, IC4203 (SAPM01N: Nch, SAPM01P: Pch output
POWER MOS Tr.) /POWER AMP-L Assy
2. R4219 (ACN7121: 0.18 Ω .5W ×2 cement source resistor)
R4217, R4218 (RS1/16S471J: 470 Ω chip resistor for
protection circuit)
D4201, D4203 (UDZS10B: 10V Zener diode for current
limiting)
D4202, D4204 (1SS355: Small signal diodes same as above)
R4210, R4211 (RS1/16S560J: 56 Ω chip gate resistor)
R4206, R4207 (RS1/16S101J:100 Ω chip IC4101 power filter
resistor) /POWER AMP-L Assy
3. IC4201 (PA9010A: Power amplifier with output current bias
Voltage step HIC) /POWER AMP-L Assy
4. Q2231 (2SA1514K) /VH TR Assy
Q2232 (2SC3906K) /VH TR Assy
Q2233 (2SA1837D1) /VH TR Assy
Q2234 (2SC4793D1) /VH TR Assy
www
.
5
http://www.xiaoyu163.com
6
x ao u163
y
i
6
http://www.xiaoyu163.com
7
2 9
8
Q Q
3 6 7 1 3 1 5
co
.
VSX-1015TX-K
7
8
9 4 2 8
0 5 8 2 9 9 4 2 8
m
9 9
A
B
C
9 9
D
E
F
113
8