Troubleshooting - Pari BOY SX Instructions For Use Manual

5 TROUBLESHOOTING

Table: Faults
Fault
The compressor
does not start up.
No medication is
coming out of the
nebuliser.
In the event of faults that are not listed in this chapter, or if the
In the event of faults that ...
suggested procedure does not correct the fault, contact the
PARI GmbH Service Center [See also: 7.4 Contact].
- 42 -
Possible cause
The power cord is not
plugged into the device
properly.
The power plug is not
plugged into the mains
socket properly.
The nebuliser nozzle is
blocked.
The connection tubing
is not connected
properly.
The connection tubing
is leaking.
Procedure
Check that the power
cord is seated correctly
in the compressor
power cord socket.
Check that the power
plug is seated correctly
in the mains socket.
Clean the nebuliser.
Check that both ends
of the tubing are seated
properly.
Replace the
connection tubing.