Advertisement
Conversion from crib using Adult Conversion Kit by Baby's Dream (sold separately).
Step 1: ***If you are converting from crib to adult bed, follow these
steps. If not, please move on to step 2.
Remove the Mattress Support by removing the four M6*15mm
bolts with the
Allen Wrench.
Using the same
wrench, you are
then going to
remove the Front
Frame Assembly
connected with
the two M8*25mm
bolts and two
M8*80mm bolts.
Finish by
removing the Side
Frame Assemblies
by removing the rest of
the M8*25mm bolts and
M8*80mm bolts that attach the
sides to the Back Frame Assembly
with the Allen Wrench.
Step 2:
To attach the metal side rails (packaged in
the Adult Conversion Kit) to the
Headboard and the Footboard, you will
need eight M8*25mm Round Head Bolts, eight M8 Metal Washers, eight Plastic Washers, and
your Allen Wrench. You're going to align a Plastic Washer followed by the adult rail then the
M8 Metal Washer and the M8*25mm bolt in the second-to-bottom and third-to-bottom holes.
The Plastic Washer should be between the back or front frame and adult rail. Tighten the bolts
at this time. ***Repeat the steps for the Front Frame Assembly and the opposite side adult rail.
Step 3:
To attach the five metal cross slats to the metal side rails, you will need ten M8*25mm Round
Head Bolts, ten M8 Metal Washers, and the Allen Wrench. You will align the M8*25mm Round
Head Bolts with the M8 Metal Washers then pass them through the pre-drilled holes under
the metal adult rails. Slide the bolt into the nut in the metal cross slats and tighten the bolts at
this time using the Allen Wrench. ***Repeat the steps for each metal cross slat on both sides
of the metal rails.
Step 4:
In the Front Frame Assembly, you will need to cover the holes on the balls in the top rail
corners and on the post of the Back Frame Assembly. For this, you need two bolt caps, two
M8*60mm Flat Head Bolts, two M8*25mm Flat Head Bolts and the Allen Wrench. Insert the
caps on any of the balls through the upper hole and attach the M8*60mm Flat head Bolt
through the bottom. Then, insert the cap on any of the upper holes on the Back Frame post
through the front of the post and attach the M8*25mm Flat Head Bolt through the back.
Tighten the bolts with the Allen Wrench at this time. ***Repeat the steps for the opposite ball
and opposite post. Now your adult bed assembly is complete.
The adult bed is not intended to be used by children under 6 years of age without proper adult
supervision. This adult bed is NOT a toy. DO NOT allow children to play or climb on adult bed.
ADULT BED CONVERSION
Advertisement
