Stanley FatMax FMC792 Original Instructions Manual

Stanley FatMax FMC792 Original Instructions Manual

Cordless nailer

Advertisement

FMC792

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the FMC792 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Stanley FatMax FMC792

  • Page 1 FMC792...
  • Page 4 ENGLISH (Original instructions) 15 15...
  • Page 5: Intended Use

    3. Personal safety a. Stay alert, watch what you are doing and use common Your Stanley FatMax FMC792 cordless nailer has been de- sense when operating a power tool. Do not use a signed for nailing. This appliance is intended for professional and private, non professional users.
  • Page 6: Safety Of Others

    ENGLISH (Original instructions) e. Maintain power tools. Check for misalignment or Use clamps or another practical way to secure and binding of moving parts, breakage of parts and any support the workpiece to a stable platform. Holding the other condition that may affect the power tools work by hand or against your body leaves it unstable and operation.
  • Page 7: Residual Risks

    The vibration level may Chargers increase above the level stated. Use your Stanley FatMax charger only to charge the When assessing vibration exposure to determine safety battery in the tool with which it was supplied. Other measures required by 2002/44/EC to protect persons regularly batteries could burst, causing personal injury and damage.
  • Page 8: Important Charging Notes

    ENGLISH (Original instructions) Symbols on charger The charger is intended for indoor use only. The green LED will flash indicating that the battery is being charged. Read the instruction manual before use. Electrical safety The completion of charge is indicated by the green LED Your adapter is double insulated;...
  • Page 9: Operation

    (Original instructions) ENGLISH Longest life and best performance can be obtained if latched into position. the battery pack is charged when the air temperature is To remove battery pack between 18°- 24°C. DO NOT charge the battery pack in an air temperature below +4.5°C, or above +40.5°C. This Depress the battery release button (B1) as shown in Figure B is important and will prevent serious damage to the battery and pull battery pack out of appliance.
  • Page 10: Low Battery Indicator

    ENGLISH (Original instructions) Work lights (Fig. F) Wear eye and ear protection. Remove battery from tool and fully charge. There are work lights (5) located on each side of the nailer. Ensure magazine is empty of all fasteners. Work lights turn on upon depressing the contact trip. Check for smooth and proper operation of contact trip and Note: These work lights are for illuminating the immediate pusher assemblies.
  • Page 11: Replacement Parts

    The tool will now be operational. engaged. Note!Should nails continue to jam frequently in contact trip, Tool doesn’t Motor stops running Normal operation; release have tool serviced by an authorized Stanley FatMax service actuate. after 2 seconds. trigger or contact trip and (Headlights on, re-depress.
  • Page 12: Maintenance

    Drive energy approx Maintenance Weight (bare tool) Your Stanley FatMax corded/cordless appliance/tool has been designed to operate over a long period of time with a minimum Fasteners of maintenance. Continuous satisfactory operation depends upon proper tool/appliance care and regular cleaning.

Table of Contents

Save PDF