Packaging blade: The unit is supplied in packaging to prevent it from Turning clockwise reduces the distance between the cutting unit and the counter blade. Turning being damaged in transit. The raw materials in this counter-clockwise increases the distance packaging can be reused or recycled. between the cutting unit and the counter blade.
Page 7
If you interrupt your work to move to a different inspection, cleaning or other work on the shredder position it is imperative to switch off the shredder and whenever it is not being used. while you are moving there. Before you begin your work, examine the material Never use the shredder in the rain or in moist or you want to shred.
allow the machine to come to a standstill. Pull the 2. Technical data plug and carry out the following work: Voltage: 230 V ~ 50 Hz - Check the machine for signs of damage 2000 W (S1) - Check that all the parts are secure and tighten Power rating: 2500 W (S6-40%) them if necessary.
5. Installation Position “⇓” The material is automatically drawn in by the blade and shredded. 1. Screw the motor unit (Fig. 4/Item 1) and the base frame (Fig. 4/Item 3) together. Use the screws Position “⇑” (Fig. 3/Item 12) and washers (Fig. 3/Item 13) to The blade rotates in the opposite direction to release do so.
Entangled branches and leaves should be tho- 7. Maintenance and storage roughly shredded before loading any more materi- Clean the machine regularly. This will help to keep Do not allow the discharge opening to become the machine in good working order and is the clogged with shredded material –...
10. Troubleshooting Fault Cause Remedy The motor does not start Power failure Check the mains lead, plug and fuse. Safety switch on the debris box not Ensure debris box is in position locked in position and locked. Material is not drawn in by the The shredding blade is running in Change the direction of rotation.
Page 13
t For EU countries only Never place any electric tools in your household refuse. To comply with European Directive 2002/96/EC concerning old electric and electronic equipment and its implementation in national laws, old electric tools have to be separated from other waste and disposed of in an environment-friendly fashion, e.g.
Page 16
The reprinting or reproduction by any other means, in whole or in part, of documentation and papers accompanying products is permitted only with the express consent of ISC GmbH. Technical changes subject to change EH 10/2007...