Operation - Black & Decker GC150 Instruction Manual

B
AUXILIARY HANDLE ASSEMBLY
• Position the auxiliary handle (3) on the
upper tube (7).
• Align the locking block (8) with groove in
tube.
• Slide the bolt (9) into the handle and
through the block and tighten (Figure C).
C
7
• Adjust the height of the auxiliary handle
(3) by loosening the bolt (9) and sliding the
handle up or down the tube (Figure D).
D
SHROUD ASSEMBLY (FIGURE E)
• Align the snap tabs of the shroud (4) to
the housing slots. Apply even pressure to
shroud until snap sound is heard.
• Ensure all snap features are engaged
correctly.
WARNING:
NEVER OPERATE TOOL
WITHOUT SHROUD FIRMLY IN PLACE.
6
9
8
E
TINE ASSEMBLY (FIGURE F)
NOTE: Do not assemble tines (5) without
first attaching the shroud (4).
• Place tine (5) on shaft (10), making sure
the flat side of the hole of tine is aligned
with flat side of the shaft. Be sure to
push tine completely onto shaft.
• Insert straight end of pin (11) into shaft
hole. Push in pin completely until the
looped end bottoms out against the shaft.
• Repeat for other tine. For tine removal
reverse the process.
F
11
10

OPERATION

WARNING:
persons and pets are at least 20 feet away.
• Hold tool as shown in figure G.
G
• Lift unit out of soil.
• Pull back on lock-off button (1).
• Pull switch trigger (2). Once the cultivator
is on, you can release the lock-off button.
For the first cultivating each season, it is best
to move slowly because dirt is packed down.
Subsequent cultivating will be completed more
rapidly. Do not attempt to cultivate when the
5
Make sure that other