Table of Contents
Advertisement
O
S
D
PENING THE
TOVE
OOR
To open the stove door pull on the door handle to
release it from the magnet. Swing the handle out
to the right until the mechanism engages and the
door catch is released.
N.B. When closing the door keep the door handle
out to the right until the door is closed.
L
IGHTING
We recommend that you have two or three small
fires before you operate your stove to its
maximum heat output. This is to allow the paint
to cure in steadily and to give a long service life to
the paint finish. During this curing in process you
may notice an unpleasant smell. It is non-toxic,
but for your comfort we would suggest that
during this period you leave all doors and
windows open.
Open both air controls fully and light one or two
firelighters placed centrally on the bottom of the
firebox, allowing the flames to become established
before placing several pieces of small dry kindling
in a crisscross fashion above the firelighters, taking
care not to smother the fire. Close the stove door.
Once the kindling is well alight open the door and
build the fire by gradually adding slightly larger
pieces of wood, closing the door afterwards.
Once the fire is established close the Ignition Air
Control (anti-clockwise) and add more fuel as
necessary. The Combustion Air control can now be
used to regulate the burn rate of the stove (see
Recommended Settings).
Should the fire fail to light correctly open the door
and use a poker to spread the fuel across the
bottom of the firebox. Close the door and allow
the fuel and stove to cool before attempting to
relight the fire.
N.B. Leaving the air controls in the closed position,
adding too much fuel or using wood that is wet or
too large will prevent the fire from establishing
JINDLE04 Rev B 15/09/15
correctly and may result in smoke emission from
the stove.
When the stove is up to operating temperature the
operating tool or gloves should be used to operate
the air controls.
R
S
ECOMMENDED
ETTINGS
Once the fire is established the Ignition Air Control
should be fully closed and the Combustion Air
Control turned to a setting of approximately 50 -
60% open. This setting should allow the nominal
output and efficiency to be achieved.
Avoid running the stove on very low air settings
as this could result in a reduction in efficiency and
increase emissions into the atmosphere.
REFUELLING
Avoid refueling on to a low firebed as this may
cause excessive smoke emission. Ensure there are
sufficient embers to ignite the new fuel load
rapidly. Alternatively add some more kindling
before adding larger pieces of firewood.
Do not add firewood above the level of the tertiary
air inlet at the back of the stove. Exceeding this
amount can result in the production of excessive
smoke.
D
-A
E
SHING
From time to time it will be necessary to remove
excess ash from the firebox. This can be done by
lifting up the log retainer to release it from its
supports and removing the ash with a small shovel.
Advertisement
Table of Contents
