Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for D&R HYBRID-1
Summary of Contents for D&R HYBRID-1
- Page 1 TELEPHONE HYBRID-1 USER MANUAL V.1.06 page-1...
- Page 2 All functions are self-explanatory and you will certainly appreciate the ergonomics of this design. We are confident that you will be using the Telephone Hybrid-1 for many years to come, and wish you a lot of suc- cess.
- Page 3 What is a Telephone hybrid? Telephone hybrids provide the interface between professional audio equipment and the public telephone network. They provide protection for your equipment and the public telephone lines, allowing for varying line signals and line conditions. Automatically canceling out the unwanted signal they also facilitate two-way communication down a single telephone line.
-
Page 4: Wiring Scheme
(all other Aux. sends need to be open), or in broadcast mixers a clean-feed is the best. The Hybrid-1 stereo jack connector labelled TO MIC INPUT has to be connected to a Mic level input of your mixing console. - Page 5 SPECIFICATIONS AUDIO TO CLEAN FEED OUTPUT Impedance : 10k Ohm, electronically balanced Common mode rejection : >30dB Maximum input level : +26dBu Nominal input level : +4 dBu Frequency response : 20Hz – 15kHz Connectors : STEREO JACK TO MIC INPUT Impedance : <...
-
Page 6: Mic Input
AUDIO CONNECTIONS TELEPHONE HYBRID TO AIRMATE From Cinch connector Connect of the Clean feed output “To Clean feed output” of the AIRMATE of the HYBRID-1 (Cleanfeed output could also be an AUX send output) ______________________________________________________________________________________________ Connect to Connect to MIC INPUT “... - Page 7 2. Mic input of the mixer must be connected to “TO MIC INPUT” of the Hybrid. As the Hybrid-1 is a passive unit signal loss is to be expected so drive it with a maximum signal and connect the return telephone signal always to a mic input of your mixer.! Above you see the XLR connections if your mixer has balanced or unbalanced XLR type of connectors on the mixer side.
- Page 8 RJ11 type of cable to do the wiring in between telephone set and the mixer and between the wall connector outlet from phone company and the Hybrid-1 page-8...
-
Page 9: Setting Up Procedure
SETTING UP PROCEDURE Connect a telephone appliance at the back of the Telephone Hybrid-1 (most left RJ11 connector) and connect the (wall) phone line RJ11 connector to the “wall”. Push the "to caller" switch to connect the audio to the caller and leave the "connect"... -
Page 10: Declaration Of Conformity
Name Manufacturer D&R Electronica Weesp b.v. Address Manufacturer Rijnkade 15B, 1382 GS Weesp, The Netherlands declares that the product Name product TELEPHONE HYBRID-1 Model number HYBRID Product options Complies with the following product specifications: Security EN 60950: 1988 +A1, A2... -
Page 11: Product Safety
PRODUCT SAFETY This product is manufactured with the highest standards and is double checked in our quality control department for reliability in the "HIGH VOLTAGE" section. CAUTION Never remove any panels, or open this equipment. No user serviceable parts inside. Equipment power supply must be grounded at all times. Only use this product as described, in user manual or brochure. - Page 12 TELEPHONE HYBRID SERVICE MANUAL Date: 07-12-2011 [ [16:17] B I L L O F M A T E R I A L D & R Electronica Weesp BV ( SERVICE-MANUAL ) Comp: 60898508 Telephone Hybrid-1g 9.5" ---------------------------------------------------------------------------------------------------------- Article code Description Quantity Unit ---------------------------------------------------------------------------------------------------------...
- Page 13 17:09:45 2013 page-12...