Advertisement
There are two power options:
1.
Use the Li-Ion Battery:
The DVR can be activated after it has been placed on the vehicle by pressing the POWER ON/OFF
button for three seconds, and can be turned off by pressing it again.
Charging: connect with the USB cable or car charger. The power button indicator turns red and
turns off when the battery is fully charged.
2.
Connect with Car Charger:
The DVR will record automatically when the car starts, then will turn off and save the last file when
the car stops and the engine is turned off.
Note: Just 5V of output voltage is required.
1.
Insert an SD memory card into the SD/MMC memory card slot.
2.
Install the bracket into the mounting hole on the camera, then position the suction cup in a suitable
location. Adjust the location and direction so that it is pointing in the desired direction and does
not block your view of the road more than required.
3.
Plug the car charger into the DC 5V connector in your car, then connect the other end to your
camera.
4.
Hold the POWER ON/OFF button for three seconds to turn on your camcorder. Adjust the
settings as required.
DVR will enter into default video mode when turned on. The recording file will be saved onto the SD/MMC
card. To stop recording, press REC. (When powered up on battery power alone, press the REC button to
start the recording).
Turn on the DVR and press the MODE button to enter into camera mode. You can then take a photo by
pressing the REC button.
Turn on the DVR and press the MODE button twice to enter into playback mode. Press UP or DOWN to
select the previewed file. If it is a video file, you can play or stop the video by pressing the REC button.
In Playback Mode, press the MENU button to enter into the delete interface. Press REC to choose between
Single/All/Select modes. Press UP/DOWN to confirm, then press the REC button to delete.
You can select Thumbnail mode to preview more files, volume (from 1 to 8) and file protect under the
Playback Mode.
2
Advertisement
