Honeywell Avanza SE.40B1 User Manual page 14

SIGNAL TYPE
Depending on the equipment you have attached, select either Cable (with
or without a Cable Satellite box) or Air (Antenna).
AUTO CHANNEL SEARCH
Press Enter on your remote to begin scanning for available channels in
your area. This may take several minutes.
SELECTING CHANNELS
While in TV mode, the following can be used to select and navigate
channels:
1. Press CH+ or CH- on your remote to navigate up or down through
channels.
2. Use the numeric buttons (0-9) to input channel numbers directly.
3. Press the channel return button
channel that was selected.
NOTE: If no channels appear, please refer to pg. 11 to run a channel scan.
ADJUSTING THE VOLUME
To adjust the volume on your TV, press the VOL+ to increase the volume
and press the VOL- button to decrease. To mute your TV, press the MUTE
button on your remote. To unmute, press the MUTE button again.
SE.40B1 User Manual
SELECTING AN INPUT SOURCE
To display this input source menu, press the INPUT
button on your remote.
Once the menu is displayed, use the up and down
arrows to navigate through the menu. When you
have highlighted the correct input, press the
ENTER button to select that input.
to go back to the previous
13