Table of Contents
Advertisement
System Armed & Activated
Regardless of method used to Arm the alarm, once Armed, the alarm will monitor
all protected zones, and if an intrusion attempt is detected it will activate, or
"trigger".
A trigger consists of the following:
• The electronic siren, or optionally the vehicle's horn, will start sounding.
• The exterior parking lights will flash on and off repeatedly.
An activation has a 30 second duration unless the system is disarmed using the
remote control or the Valet /Override switch. If all protected zones are secure at
the end of the trigger, the system will stop and rearm itself to detect further entry
attempts. If a protected zone is still open at the end of the trigger cycle, the alarm
will continue to re-trigger itself for up to six activated cycles before it resets itself
and ignores the violated zone.
Remote Panic Operation
Should it be needed in a threatening situation, or you feel the need to attract
attention, the alarm can be triggered using the remote control. Your alarm fea-
tures "Panic Mode", which allows you to activate "Panic" from the "Arm/Lock"
button.
To Activate Remote Panic: Press & Hold the "Arm/Lock" Button,
for 3 seconds, with the ignition "Off".
THE SIREN WILL SOUND
Hold 3 seconds
THE PARKING LIGHTS
WILL FLASH
Sensor By-pass
The shock sensor & Prewarn zone can be by-passed using the remote
control. This may be useful in stormy weather.
1) Arm the alarm by, Pressing & Releasing the "Lock" button.
2) Within 2 seconds, Press & Release the
button.
"3rd"
1.
2.
Then
- The siren will chirp once to confirm sensor has been by-passed.
- Upon Disarming the alarm, the sensor zone will reset.
Page 5
Advertisement
Table of Contents
