í À \
B R A K E M I C R O ,
''*'
swtTcH
\
o
55os !5og
BRAKE LEVER
F i g . 1 2
ERAKE LEVER
Fig. I I
F i g . l 3
BRAKE BAND POSITION ADJUSTI\{ENT
AND BRAKE TENSION ADJUSTMENT
(Refer to Figs. 11 to 13)
1) Adjust the brake lever to 180" position by loosen-
ing the screws (a) and (a').
2) Work the brake plunger to check that the brake
band is not slanted.
3) Adjust the position of the part with screws (b) and
(b') to obtain a brake tension of 550 1 50g on
both brakes at stop mode.
(Use a 10009 spring gauge for a reel with 60 mm
diameter of tape.)
In case the specified brake tension cannot be
obtained, connect the springs to the other holes
on the brake lever and adjust.
4) By working the brake plunger with a finger, adjust
the position of the microswitch screw (c) so that
the gap between the brake lever and the micro-
switch body is 0.5 to 1.0 mm.
6 .
E
€
IL
25