Table of Contents
Advertisement
Time
Receive or Transmit time of message.
ID
Target ID of this message. (Hexadecimal value)
Tx/Rx
Tx: Transmit message, Rx: Receive message.
RTR
Indicate this message is Remote Transmit Request or not.
DLC
Data length (UNIT : bytes)
Data
Data content of this message (Hexadecimal value).
Operation procedures for main screen
Select CAN Bus baud rate and mode, click "Open" button to open CAN Bus. The text of
Step1.
button will become "Close" and the program will start to update information in status
area if CAN Bus is opened successfully.
Mask/filter setting values then click "Set" button to change current filter setting of CAN
Step2.
Bus.
All transmit and receive messages will be shown in the message list. Click "Clear data"
Step3.
button could clear content of message list.
Click "Send setting" button to set up transmit data. More detail information about
Step4.
transmit data setting could be found in the
could pause or resume the transmit by Send data switch.
If user wants to change baud rate, please close CAN Bus by click "Close" button first.
Step5.
Click "Exit" button to close CAN bus and exit the program.
Step6.
<Transmit Data Setting>
97
Rev. V0.6
paragraph.
User
Advertisement
Table of Contents
